UleFone UF005 15W Wireless Charging Pad User Guide
- June 3, 2024
- uleFone
Table of Contents
UleFone UF005 15W Wireless Charging Pad User Guide
Package
Con tents Wireless charging pad x 1
USB Type-C cable x 1
Quick guide x 1
How to Charge Your Phone?
- Before starting charging, please connect the charging pad to the power adapter with the USB Type-C cable, and then plug the power adapter into the power outlet.
- Please co『,ectly place the phooe wh;ch 叩pports w;,eless cha勺;,g f”ocboo oo the wkeless cha,g;,g pad, the, the phooe wnl show that ;t ;, cha屯;,g
Note,
-
For optimal charging performance, please use QC / PD power adapter
-
The wireless charging pad comes with multiple protection mechanisms. When charging abnormalities occur, please check the phone status and deal with it, then reposition the phone in the right place
-
If your phone is equipped with a protective case, please remove the case before charging and place the phone correctly on the wireless charging pad
If the phone is installed with a thick protective case or the case contains metal substances, the phone may not charge properly or the case may become hot -
To keep the wireless charging pad in good condition, please do not use the wireless charger in car.
-
Please do not put the bus card, bank carc and other chip cards together with your phone to charge, otherwise it may affect the charging or the normal use of your card
instructions for LED Indicator Light
Worling Status | LED Indicator Light Status |
---|
Power On
| Red light blinks 3 times, blue light is always on
Charging| Red light is always on
Foreign Materials| Red light and blue light
alternately blink
15W Wireless Charging Pad Model: U FOOS Universal Input: 5V= 2A Fast Charge Input: 12V= 2A Universal Output: 5W Fast Charge Output: 15W Made in China
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines,
This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.