Blackiehead G4N5E7 Soap Dispenser User Guide
- June 6, 2024
- Blackiehead
Table of Contents
Blackiehead G4N5E7 Soap Dispenser
Get to know your Smart Soap Dispenser
Indicator light colors
Setup
Blue flashing: Ready for setup
Blue solid: Setup complete
Battery
Green: Fully charged
Orange: Charging
Getting started
Add liquid hand soap
-
Make sure the device is powered off.
-
Turn the lid 45 degrees counterclockwise to open.
-
Flit liquid hand soap of your choosing to the MAX line.
-
Turn the lid 45 degrees clockwise to close.
Note: filling above MAX line can cause spillage.
If you’re not setting up your device with Alexa, you can turn It on and start using it now. If you are, continue to step 2 before using the dispenser.
How does dynamic dispensing work?
Place your hand farther from the nozzle for more soap and closer for less. A few seconds after dispensing, the 20-second timer will begin.
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This device has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiated radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.
RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>