Shenzhen Xingyuansheng Electronic Technology X2 Wireless Charger Instructions
- June 6, 2024
- Shenzhen Xingyuansheng Electronic Technology
Table of Contents
Xingyuansheng Electronic Technology X2 Wireless Charger
Instructions
Precautions for use
- The original Apple adapter DC5V/1A can be used, and the powerbank output specification is DC5V/1A/2A.
- When using this product, check to make sure that the power adapter output voltage used is “DC5V”. If the voltage is out of range, it will be permanently damaged; if the voltage and current are insufficient, it will not work properly.
- Recommended for use in environments below 26℃.
- If used, please disconnect the power to avoid power consumption.
Product parameters
Interface:USB
Input:5V=1A
Output:2.5W
Warning: Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
FCC Warning Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This device complies with part 18 of the FCC Rules.
Information to the user.
- the device has potential interference, but the interference is very small and meets the requirements of the FCC rule
- Equipment system maintenance is simple, please refer to the manual.
- The user can take simple measures to correct the interference. Such as staying away from interference sources, turning off interference sources, etc.
RF exposure compliance statement:
The equipment complies with the FCC Radiation exposure limit set forth for
uncontrolled environments. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>