BRESSER 7009999 Thermo/Hygro 7 Channel Sensor 868MHz Instruction Manual
- June 6, 2024
- BRESSER
Table of Contents
BRESSER 7009999 Thermo/Hygro 7 Channel Sensor 868MHz
Thermo-Hygro-7CH-Sensor 868MHz Art. Nr.: 7009999
Instruction Manual
General Warning
DANGER!
This device contains electronic components which operate via a power source
(power supply and/or batteries). Do not let children use the device while
unattended. Only use the device as described in the manual, otherwise you run
the risk of an electric shock.
Children should only use the device under adult supervision. Keep packaging
material, like plastic bags and rubber bands, out of the reach of children, as
they pose a choking hazard.
Keep batteries out of the reach of children. Make sure you insert the
batteries correctly. Empty or damaged batteries could cause burns if they come
into contact with the skin. If necessary, wear adequate gloves for protection.
DANGER!
Do not expose the device to high temperatures. Use only the recommended
batteries. Do not short-circuit the device or batteries, or throw them into a
fi re. Excessive heat or improper handling could trigger a short-circuit, a fi
re or an explosion!
NOTE!
Do not disassemble the device. In the event of a defect, plea-se contact your
dealer. The dealer will contact the Service Centre and can send the device in
to be repaired, if neces-sary.
Use only the recommended batteries. Always replace weak or empty batteries
with a new, complete set of batteries at full capacity. Do not use batteries
from different brands or with different capacities. The batteries should be
removed from the unit if it has not been used for a long time.
NOTES ON CLEANING
Separate the device from the power supply or remove the batteries before
cleaning.
NOTE!
Only use a dry cloth to clean the exterior of the device. Do not use any
cleaning fl uid to avoid damaging the electronics.
SCOPE OF DELIVERY
Outdoor sensor, instruction manual, batteries required (not included): 2 pcs.
Batteries (1.5V, type AA)
FEATURES OF THE REMOTE UNIT
-
LED INDICATOR
Flashes when information is being transmitted to the weather station. -
WALL MOUNT
For mounting the sensor on walls. -
SET THE TRANSMISSION CHANNEL
(1-7) Input channel for the weather station. Set the channel before inserting the batteries. -
RESET BUTTON
Press to reset all setting if you have selected different channel.
-
BATTERY COMPARTMENT
Unit requires 2 pcs. UM-3 or “AA” 1.5V batteries. -
FIRST OPERATION
- Open the battery compartment cover.
- Set the desired channel with the switch. If you are using only one transmitter, please leave the selection at „1“.
- Insert 2 new UM-3 or „AA“ 1.5V batteries observing correct polarity.
- Close the battery compartment cover and set the unit in the desired location.
Although the outdoor sensor is weatherproof, it should not be placed in places exposed to direct sunlight, rain or snow.
TIPS FOR SETTING UP:
Please follow the instructions below to ensure optimum operation of the
equipment:
- Assign each external transmitter unit its own channel.
- Place the receiver unit and transmitter unit within 1 meter of each other and activate the manual search for available signals from all connected outdoor sensors on the main unit (weather station not included with delivery).
DISPOSAL
Dispose of the packaging materials properly, accor-ding to their type, such as paper or cardboard. Contact your local waste-disposal service or environmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage! As per the Directive 2002/96/EC of the Euro-pean Parliament on waste electrical and electronic equipment and its adaptation into German law, used electronic devices must be collected separately and recycled in an environmentally friendly manner.
In accordance with the regulations concerning batteries and rechargeable
batteries, disposing of them in the normal household waste is explicitly
forbidden. Please make sure to dispose of your used batteries as required by
law — at a local collection point or in the retail market. Disposal in
domestic waste violates the Battery Directive.
Batteries that contain toxins are marked with a sign and a che-mical symbol.
- battery contains cadmium
- battery contains mercury
- battery contains lead
EC DECLARATION OF CONFORMITY
Hereby, Bresser GmbH declares that the equipment type with part number: 7009999 is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.bresser.de/download/7009999/CE/7009999_CE.pdf
UKCA DECLARATION OF CONFORMITY Bresser GmbH has issued a „Declaration of Conformity“ in accordance with applicable guidelines and corresponding standards. The full text of the UKCA de-claration of conformity is available at the following internet address: www.bresser.de/download/7009999/UKCA/7009999_ UKCA.pdf
TECHNICAL DATA
Measurement
- Temperature range: -40-60 °C (-40-140 °F)
- Temperature steps: 0.1 °C/°F
- Humidity range: 20-95% RH
- Humidity steps: 1%
Transmission
- Transmission frequency: 868 MHz
- Maximum transmission power < 25mW
- Transmission range: 100 meters (free fi eld)
- Power supply
- 2x AA 1.5V batteries (not included)
DE-46414 Rhede
Germany
Web: www.bresser.de/weather E-Mail:
service@bresser.de
References
- Bresser | BRESSER Thermo-/Hygro-Sensor 7 Kanal 868 MHz | Expand Your Horizon
- Bresser | Batterie Anweisung | Expand Your Horizon
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>