Shenzhenshihuihaobaozhuangkejiyouxiangongsi ST-X5D-BL 3 In 1 Foldable Charging Station User Manual
- June 6, 2024
- Shenzhenshihuihaobaozhuangkejiyouxiangongsi
Table of Contents
3 IN 1
Foldable Charging Station Model NO. : ST-X5D-BL
Input: DC5V2A-DC5V3A 13)
Output: Phone: DCSV/2A(Max)
Watch: DC5V/0.5A(Max)
Earphone: DC5V/0.5A(Max)
PART LIST
Ways to Use
-
Stand the watch charger upright to charge.
-
Press the red area to make the connector tip stand upright.
-
Put the AirPods on to charge. Press the red area to make the connector tip stand upright.
Find a suitable and stable charging angle for your phone, then put the iPhone on to charge. -
The phone can be placed horizontally.
WARM TIPS
- The maximum upright angle is 75 degrees. Force might break the stand.
-
- Reach us by your Amazon order detail page (select “order” “sold by” or “contact seller”) for a warranty about it.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm the radiator
your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>