Hewlett Packard Enterprise G-Series LTE Sensor Installation Guide

June 6, 2024
Hewlett Packard Enterprise

Hewlett Packard Enterprise G-Series LTE Sensor

Package Contents

Hewlett-Packard-Enterprise-G-Series-LT-Sensor-1

connectivity & status light

This sensor requires an Ethernet connection. Make sure the sensor can connect to the Internet through access on port 80 and port 443.

Troubleshoot sensor status

Status lights will blink green when ready to configure. Please take note if status lights are one of the following colors:

  • yellow: rebooting
  • Orange: No connectivity
  • Red: sensor issues

If one of these colors persists for several minutes, please restart the setup process with the sensor plugged into an unrestricted Ethernet port. For additional help with sensor installation, go to sensor.arubanetworks.com/install.

Connecting power

Hewlett-Packard-Enterprise-G-Series-LT-Sensor-4

Installing your sensor

Use supplied screws and anchors to mount the bracket to any surface. Slide the sensor onto the bracket after connecting the Ethernet cable. If adhesive mounting is used, the sensor must be mounted below 6.5ft (2m) in height. See sensor.arubanetworks.com/install for additional mounting instructions.

Security screw

Location checklist

Hewlett-Packard-Enterprise-G-Series-LT-Sensor-10

Configuring your sensor

Wait for status lights to blink green.

Configuring your sensor at: sensor.arubanetworks.com/start

If there is no connectivity configure your sensor with a mobile application. sensor.arubanetworks.com/install

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals