OBDResource P02 Bluetooth 4.0 Scanner Professional Automotive Diagnostic Tool User Guide
- June 6, 2024
- OBDResource
Table of Contents
OBDResource P02 Bluetooth 4.0 Scanner Professional Automotive Diagnostic
Tool
INSTALLATION INSTRUCTIONS
-
Get the Faslink app visit obdresource.com/apps or scan the QR code
-
Plug P02 into the O8D port
OBD port is usually in driver’s footwell -
Turn the iginition to the “Key On, Engine Off” position
-
Enable bluetooth on the phone, tap ” CONNECT” in FasLink X
-
Tap “O8D11” bluetooth device
-
“CONNECTED”: ready to test
“CONNECTED”: ready to test
- Leave review
- _www.obdresource.com
Did we mess up?
Let our friendly support team make
info@obdresource.com
Troubleshooting
Unable to connect to vehicle:
Make sure the ignition is in the “ON” position.
Unable to pair:
Make sure connect P02 internal App, DO NOT pair bluetooth in phone setting
P02 Bluetooth device not appearing in Faslink device list on Android
phone:
Please plug out and re-instert the device to car OBDI I port. End the
Please plug out and re-instert the device to car OBDI I port. End the paired
the P02 in phone settings, paired the P02 in phone settings,
Scan QR code
Join Facebook group Join Facebook group
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
PdfEditor 4.0.0.14 Testversion – https://www.pixelplanet.com/de/pdfeditor/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>