Vanbus YISCAA Upgrade Glass Washer 9 Hole Jet Glass Rinser for Kitchen Sink User Manual
- June 1, 2024
- Vanbus
Table of Contents
Vanbus YISCAA Upgrade Glass Washer 9 Hole Jet Glass Rinser for Kitchen
Sink
STANDARD ACCESSORIES LIST
| No | Name | Qty |
|---|---|---|
| 9 | Mix Metal Cup Holder | 1 |
8
| Brass valve with 10 spraying holes|
1
7| 304 Stainless steel plate| 1
6| Rubber gasket| 1
5| Stainless steel gasket| 1
4| ABS Nut| 1
3
| 3/8 Brass water line adapter|
1
2
| 304 Stainless steel Waster supply hose|
1
1| Installation instruction| 1
Check accessories
Standard List of Accessories:
When you open the product packaging, please check whether the objects in it
are consistent with the main body and accessories you purchased. If there is
any inconsistency, please
Note:
- Accessories are subject bu orange without prior notice if the change does not affect usage;
- The appearance of the product is subject to the physical objects you receive, and the schematic diagram is only for reference.
INSTALLATION STEPS
This product has been inspected and debugged by the factory to the best condition. Please do not disassemble and assemble it yourself.
Before installing the Glass Rinser, please be sure to remove sundries and sludge from the water pipe to prevent sundries from blocking the Glass Rinser.
Tools
Helpful Information Tools:
Gather the necessary tools as shown below to complete the installation of this
Glass rinser.
Read all instructions before installation
Tum off hot and cold water supplies at angle stops before installing the glass
rinser.
STEP1~2
Slide the mounting shank through the sink from above, then slide the shank
through the rubber washer, and then through the steel support washer.
STEP3~4
Ensure the base is aligned with the sink and the outlet extends into the basin
before fully tightening the mounting nut.
STEP5~6
Ensure the base is aligned with the sink and the outlet extends into the
basin before fully tightening the mounting nut.
Determine whether you wish for your new glass rinser to be supplied with cold or hot water. Unthread the existing faucet supply line from the angle stop on the chosen side. Thread the provided tee onto the angle stop in place of the supply line that was disconnected in the previous step. Thread both the faucet supply line and the 3/8″ end of the provided supply line to the tee.
INSTALLATION STEPS
Thread the 1/2″ end of the provided supply line to the mounting shank. A
wrench may be used on shank flats to avoid rotation. When the supply line is
installed, check alignment and retighten the mounting nut.
DIMENSION
INSTALLATION DIMENSION
CLEANING CARE
To keep the appearance of the Glass Rinser clean, bright and good performance, please take care of the Glass Rinser as follows;
- Rinse with water onlv and dry with soft cotton cloth:
- Use mild liquid and colourless glass cleaner to remove surface dirt and scale fim, or use polish without abrasive effect;
- Do not use abrasive detergent, polish, emery cloth, paper towel or scraper, etc.;
- Do not use acid cleaner, or cleaner and soap with insoluble gran etc.;
- In the process of use, mud may accumulate in the bubbler and make the water flow show, The bubbler can be unscrewed, rinsed with water, and then installed back in place.
Pls, feel free to contact us if you have any questions. We will solve this in time with this email of vanbus@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>