Dongguan Hying Digital Technology HY206 Gaming Speaker Instruction Manual

Dongguan Hying Digital Technology HY206 Gaming Speaker

Thank you for purchasing your new gaming speaker system. We recommend that you spend some time reading this manual in order that you fully understand all the operational features it offers. Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Brief Introduction

This product supports AUX-IN and Bluetooth playing as well as earphone function. Built-in DSP sound processing
Dual optical projectors and RGB led lighting.

Controls on panel interface

1. DC5V USB
   DC 5V USB powered

2. AUX-IN Φ3.5
   AUX –input for Φ3.5mm stereo jack

3. Earphone port

4. Mode

5. Volume

Operations

1. USB DC5V AUX-IN Φ3.5
   Plug the USB power cable into your DC5V power supply such as PC or DC5V adaptor. the unit implies a priority of AUX-in playing.

2. Double press the “M” key to shift to Bluetooth mode , bluetooth device is under pairing and the optical projector will flash blue lightings.
   Power on the mobile phone or other BT devices, and search “HY206”, press it to connect and input the Bluetooth pin “0000” if needed, a sound indictor will play after the connection is completed. and then the projection lamps will shine a breathing light.
   Press the “M” key shift to lighting mode , there are 4 different lighting modes plus light ON and light OFF for choice. the unit implis the light flashing mode followed music playing..
   Keep pressing the “M” key to adjust the brightness of projection lamps ( from 30-100%)

Main Parameter

• Audio input: AUX, Bluetooth
• Power supply: DC5V 1A/2A
• Output power: 2.5W+2.5W
• Frequency response: 80 Hz-20 kHz
• Separation: ≥40dB
• S/N ratio: ≥75dB
• Impedance: 4ohm
• Controls: Knob + key

Cautions

1. make sure to use it under the rated voltage DC 5V
2. Whilele a strong signal input. don’t set volume to the maximum to limit distrotion.
3. To reduce the risk of fire or product damage, do not expose this unit to rain, moisture, dripping or splashing. keep the unit in a ventilated and dry place.
4. Only use dry cloths for cleaning the units, If you spill any liquid into the unit, it can be cause serious damage. Switch it off at the mains immediately. Withdraw the USB plug and consult your dealer.
5. Do not open any fixed covers as this may expose dangerous voltages.if maintance required, Please leave all maintenance work to qualified personnel or consult your dealer.
6. Working atmosphere: under 0℃~45℃, 30-70% humidity.
7. Listening to loud sounds for prolonged period of time may momently damage your hearing.
8. Looking at flashing lights for prolonged period of time may momently damage your visus.
9. Before putting on earphones, turn the volume down and slowly increase the volume to a comfortable volume level.

FCC

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>