SARINA USBL 2-In-1 Speaker and LED Lamp Instructions
- June 6, 2024
- SARINA
Table of Contents
SOUND & LIGHT
1. LED LIGHT There are 2 LED light modes to choose from – warm white and cool white. Cool: Short press the touch switch once Warm : Short press the touch switch twice Long press the touch switch button to change the LED Brightness against above two modes.
2. BLUETOOTH SPEAKER The Bluetooth speaker will enter pairing mode as
soon as the lamp is connected to a power supply.
Activate Bluetooth function on your enabled devices (phone, tablet etc) and
set it to search for Bluetooth devices. Select the speaker when it comes up
and your device will confirm pairing. You can then start to play music through
the speaker. If requested, please enter password or PIN 0000 on your bluetooth
device and press “Yes” or “Confirm”
FCC STATEMENT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>