SARINA NOR-VSTP-BLK Selfie Tripod for Smart Phones Instruction Manual

: June 5, 2024
: SARINA

Table of Contents

PRODUCT COMPONENT INTRODUCTION
TECHNICAL SPECIFICATION
INTENDED USE
INFORMATION FOR THE SAFE USE OF BLUETOOTH SELFIE STICK WITH BUTTON
MAINTENANCE AND CLEANING
INFORMATION FOR CORRECT DISPOSAL OF THE DEVICE
BATTERY ASSEMBLY
FCC STATEMENT
Technical Specification
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SARINA NOR-VSTP-BLK Selfie Tripod for Smart Phones Instruction Manual

PRODUCT COMPONENT INTRODUCTION

PRODUCT COMPONENT

Selfie stick holder with tripod stand
Device clamp
Removable Bluetooth remote control

TECHNICAL SPECIFICATION

Wireless
Operating distance: 10m
Clamp size: 55-85 mm [max. 6″)
Closed size: 186 mm
Extended size: 700 mm
Weight: 155 g
Removable remote control with interchangeable CR1632 battery, compatible with iOS and Android

INTENDED USE

To start connection – press and hold the remote control button. Flashing blue light indicates visibility of the remote to smartphone. Find “Reinston Selfie” words on the “Bluetooth devices” through the -settings” menu of your smartphone and connect them. Once the connection has been established. The blue light will stop flashing and will turn blue. Once the Bluetooth connection has been established, pick and activate the required camera (front or rear). The device is to be placed in the clamp and you need to make sure that it has been fixed properly. Extend the telescope arm to the target length. Press the remote release button to start the selected functionality (photo, video). To switch it off press and hold the button on the remote control again. A flashing light means that the remote control has been turned off. In case of low battery of the remote control, open it by exerting a slight force on the side of the remote control and replace the internal battery. Selfie stick can be used in the traditional manner or as a tripod stand.

INFORMATION FOR THE SAFE USE OF BLUETOOTH SELFIE STICK WITH BUTTON

BATTERY

Always keep and follow the instructions given to ensure the safe use of the product and other connectable devices.
Use the product and its accessories only for their intended use and in compliance with the declared electrical characteristics and in protected environments to avoid serious dangers.
Keep away from heat, direct sunlight, humidity and liquids.
Only use the cables provided with the purchased product.
The product must not be used by children or persons unable to understand any potential danger.
Do not attempt to recharge the product or the battery inside it.
Do not drop, crush, cut or handle the product roughly to avoid dangerous situations.
Never disassemble the product or attempt to repair it in the event of a defect.
If the product leaks fluids, avoid contact with skin or eyes; if contact occurs, immediately wash the affected area with water and consult a doctor.
Do not leave packaging materials unattended, especially storage bags which are a potentially dangerous toy for children (choking, swallowing, etc.)
Avoid using the device in proximity to electro-medical devices (e.g. pacemakers).
Contact the SBS customer service department if you have any doubts regarding the operation, safety or connection method of the product.
Devices (e.g. smartphones) to be connected to the product must comply with the minimum and maximum dimensions laid down.
If the battery compartment does not close securely, stop using the product and keep it away from children.
This product contains a coin cell battery, if ingested it can cause serious internal injuries in just two hours and can lead to death. If you think the battery has been swallowed or placed within any part of the body, seek medical attention immediately.

MAINTENANCE AND CLEANING

The product does not require maintenance and should only be cleaned with a clean, soft cloth without using aggressive agents or chemical products to avoid damage to the product.

INFORMATION FOR CORRECT DISPOSAL OF THE DEVICE

The crossed-out wheelie bin symbol on the appliance or its packaging indicates that the product at the end of its useful life must be gathered separately from other waste to allow proper treatment and recycling. It is forbidden to dispose of waste electrical and electronic equipment as residential waste, as also highlighted by the symbol shown on the product and/or packaging.
Such waste is subject to separate collection organised by councils or can be returned to the retail distributor in case of purchase of a new equipment of the same type.
Unlawful disposal or improper use of such equipment or its parts may damage the environment and health due to the presence of hazardous substances. The illegal disposal of said waste is sanctioned in accordance with the current legislation.

BATTERY ASSEMBLY

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.