DISPLAY TECHNOLOGY E49 Cap Sensor Installation Guide
- June 6, 2024
- DISPLAY TECHNOLOGY
Table of Contents
DISPLAY TECHNOLOGY E49 Cap Sensor
Please read the following instructions to install the sensor onto each tire valve after programming. The sensor onto each tyre valve after programming. If the sensor has not been programmed to the monitor before installation, please refer to the Monitor Manual for sensor programming.
Specification
- Pressure Range/0-188 PSI/ 0-13 BAR
- Working Temperature/- 20°C~80°C
- Storage Temperature/ 20°C~8S°C
- Frequency Transmission/433.92MHz
- Power Pressure Accuracy/ <10dBm
- Temperature Accuracy/± 1.Spsi (±0.1 bar)
Sensor Installation
-
Screw the hex nut onto the valve stem threads until it bottoms out.
-
Screw the correctly marked sensor onto the valve stem for that tire position. Tighten the sensor until the air stops leaking and the sensor bottoms-out on the valve stem. Then give it a quarter turn more to seat it. Do Not Over Tighten!
-
Use your fingers to screw the hex nut up to the bottom of the sensor. Using the provided wrench, tighten the hex nut against the bottom of the sensor. This will prevent the sensor from being removed. Keep the wrench in a safe place for future use.
-
To inflate or deflate the tire, you must remove the cap sensor.
-
Install the anti-theft hex nut onto the tire valve.
-
Install the sensor onto the tire valve clockwise.
-
Tighten the anti-theft hex nut counter clockwise until the nut is tightened against the sensor.
Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’ s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>