DISPLAY TECHNOLOGY E35 Wireless Tire Pressure Monitoring System Instruction Manual
- June 6, 2024
- DISPLAY TECHNOLOGY
Table of Contents
DISPLAY TECHNOLOGY E35 Wireless Tire Pressure Monitoring System
Sensor installation should be carried out by a professional technician. After installation examines the tire to make sure no air leakage.
SPECIFICATIONS
Operation temperature | -20°C~8 S°C |
---|---|
Storage temperature | -20 °C~8 S°C |
Frequency | 433.92MHz |
Transmission power | < 8 d Bm |
Pressure accuracy | ±0.1 bar(±1.5 psi) |
Tern perature accuracy | ± 3°C |
Dimension | 68(L)x32(W)x20(H)mm |
Weight | 36g |
Battery Iife | >/ =3 Years or 60,000KM |
INSTALLATION
Detach tire from vehicle and shovel off the tire from tire rim (operate at > 15cm distance away from tire valve).
FCC
Warning:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in
portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>