HINO 392 Conventional Trucks Bosch Telematics Installation Guide

Conventional Trucks
Bosch Telematics
Installation Manual
HINO 392/401 VEHICLES
Taha Allali
HINO MOTOR MANUFACTURING 

Introduction

This Manual will take you to step by step on installing Bosch Telematics on HINO 392/401 Vehicles.

Getting started

The table below contains the needed tools and parts for the Bosch telematics setup.

Pre-Installation

• Record ESN Number
• ESN Label is located on the bottom of The Device (USS8990-009)
• Record VIN Number
• VIN Number is on the label located on the driver door jam

Bosch Telematics Installation Steps

Step 1 – Install Telematics Antenna (USS8990-010) on the Bracket (US89539-003)

Notes:

1. Screws are parts of the Antenna Kit (USS8990-010)
   Step 2: Install the bracket (US89539-001) on the Bracket 82715-E5D21

Notes:

1. US89539-001 will be installed only in the case of halogen light.
   Step 3: Install the Step 1 Assembly on the Bracket 82715-E5D21

Notes:

1. US89539-001 will be installed only in the case of halogen light.
2. A halogen light controller will be installed only in the case of halogen light.

Step 4: Install the Telematics Module (USS8990-009) into Bracket (US89539-002)

Notes:
Installation sequence:

1. Compress the locking springs against the locking pins
2. Insert the locking taps into the locking holes
3.  8954C-E0010 Can be installed only in the case of HYDRO BRAKES.

Step 5: Install the Step 3/4 Assemblies on the ECU Rack

Notes:

1. The dash and the rest of its components are not shown for clarity

Step 5: Install the Step 3/4 Assemblies on the ECU Rack

Notes:

1. The dash and the rest of its components are not shown for clarity

Step 6: Telematics Antenna wires and Jumper harness installation

Notes:

1. The jumper harness will get connected to the telematics module and the
   Cab main harness.

2. The Telematics Antenna wires will connect to the Telematics module.
   View A in the next page will show Detail view A.

Step 6: Telematics Antenna wires and Jumper harness installation.

Notes:

1. The telematics antenna wires connectors’ color must match the color of the telematics module connectors.
   For Example
   The blue Telematics Antenna wire connector must be connected with the blue connector in the Telematics Module.

This device complies with Industry Canada’s license-exempt RSSs and part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

To comply with FCC / ISED RF Exposure requirements, the antenna must be installed to assure a minimum separation distance of 20 cm between the antenna and any human body during normal operating conditions.

HINO MOTOR MANUFACTURING USA, INC

Documents / Resources

| HINO HINO 392 Conventional Trucks Bosch Telematics [pdf] Installation Guide
HINOTCU, 2AXKD-HINOTCU, 2AXKDHINOTCU, HINO 392 Conventional Trucks Bosch Telematics, HINO 392, Conventional Trucks Bosch Telematics
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>