Bestway 68085 Rent 3 Person Pavillo Cooldome 3 (6.11″ x 6.11″ x 4.25″) Water Resistance Owner’s Manual
- October 27, 2023
- Bestway
Table of Contents
Bestway 68085 Rent 3 Person Pavillo Cooldome 3 (6.11″ x 6.11″ x 4.25″)
Water Resistance
INTRODUCTION
Proper Use
Any use other than that described or any modification of the product is not
permissible and may result in injury and/or damage to the product. The
manufacturer is not liable for damage caused by improper use. The product is
not intended for commercial use.
Description of parts and features
Manual
1PC
Tent Dimensions:
Approx: 210cm x 210cm x 130cm（L x W x H） Outer tent: 210cm x 210cm x 130cm
Pitching dimension: 220cm x 220cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent fabric. We recommend that
you always position your tent upwind from a camp fire. This will reduce the
chances of having embers land on your tent. In case of fire, please find the
exit to escape from the fire.
Never set up the tent near the river, under the tree of other objective
hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to avoid suffocation.
SAVE THESE INSTRUCTIONS
ASSEMBLY
Setting up the tent
WARNING: Poles contain fiber glass. We strongly recommend wearing gloves during assembly to avoid irritating hands.
-
Lay the inner tent
on the ground. Pull the four corners outwards.
Note: Make sure that the channels for the poles are facing upwards.
Note: Make sure that the zip on the entrance to the tent is closed. -
Push the poles completely into the channels. (FIG1)
-
Stand the inner tent
up and push the ends of the poles into the iron bars (which are on the each corner of the inner tent . (FIG2) -
Fasten the roof of the inner tent
onto the pole junction with the sewn-on tie. (FIG2) -
Now cover the tent with the outer tent and hook the 4 loops. (FIG3)
-
Secure the tent by pushing the tent pegs
into the ground loops. (FIG3) -
Tie one end of the guy ropes
onto the four corner hoops of outer tent . (FIG4) -
Tie the other end onto the tent pegs
and fasten them by inserting the tent pegs into ground. (FIG4) -
Note: Ensure that guy ropes
are about at an angle of 45° -
Do not pull the guy ropes
too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-10 in reverse order.
- Clean the tent and remove any stains with sponge and cool water. Please use non-detergent soap for serious cleaning.
- Never machine wash or machine dry the tent. Hand wash and air dry.
- Please allow all parts to dry thoroughly before you repack the tent. This will prevent the formation from mould, bad odours and discolouration
- Stitch with thread to repair minor leaks, fabrics and plastic sheets damage. Use ropes to connect broken frame parts. Use tapes to repair the coating broken parts.
- Silicone spray could be use onto zippers if stick
STORAGE
Store the tent in the stuff sack and place it in a cool, dry area out of sunlight and away from heat sources and rodents.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>