Bestway 68002 Pavillo Multifunctional Tent Owner’s Manual
- October 27, 2023
- Bestway
Table of Contents
Bestway 68002 Pavillo Multifunctional Tent
INTRODUCTION
Proper Use
Any use other than that described or any modification of the product is not permissible and may result in injury and/or damage to the product. The manufacturer is not liable for damage caused by improper use. The product is not intended for commercial use.
Description of parts and features
Tent Dimensions：
- Outer tent: 110cm x 110cm x 190cm
- Pitching dimension: 120cm x 120cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent fabric. We recommend that
you always position your tent upwind from a camp fire. This will reduce the
chances of having embers land on your tent. In case of fire, please find the
exit to escape from the fire.
Never set up the tent near the river, under the tree of other objective
hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to avoid suffocation.
SAVE THESE INSTRUCTIONS
WARNING: Poles contain fiber glass. We strongly recommend wearing
gloves during assembly to avoid irritating hands.
ASSEMBLY
Setting up the tent
-
Push the poles completely into the channels. (FIG1)
-
Stand the tent up and push the ends of the poles into the iron bars (which are on the each corner of the tent . (FIG2)
-
Fasten the roof of the tent onto the pole junction with the sewn-on tie. (FIG2)
-
Secure the tent by pushing the tent pegs
into the ground loops. (FIG2) -
Tie one end of the guy ropes
onto the four corner hoops of outer tent . (FIG3) -
Tie the other end onto the tent pegs
and fasten them by inserting the tent pegs into ground. (FIG3) -
Note: Ensure that guy ropes
are about at an angle of 45° -
Do not pull the guy ropes
too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-9 in reverse order.
- Clean the tent and remove any stains with sponge and cool water. Please use non-detergent soap for serious cleaning.
- Never machine wash or machine dry the tent. Hand wash and air dry.
- Please allow all parts to dry thoroughly before you repack the tent. This will prevent the formation from mould, bad odours and discoloration
- Stitch with thread to repair minor leaks, fabrics and plastic sheets damage. Use ropes to connect broken frame parts. Use tapes to repair the coating broken parts.
- Silicone spray could be use onto zippers if stick
STORAGE
Store the tent in the stuff sack and place it in a cool, dry area out of
sunlight and away from heat sources and rodents.
©2019 Bestway Inflatables & Material Corp.
All rights reserved
®™ Trademarks used in some countries under license to
Bestway Inflatables & Material Corp., No.3065 Cao An Road, Shanghai,
201812, China.
Manufactured, distributed and represented in the European Union by 5, 20098
San Giuliano Milanese (Milano), Italy Distributed in North America by
Bestway (USA) Inc., 3411 E. Harbour Drive, Phoenix, Arizona 85034, United
States of America
Tel: +86 21 69135588 (For U.S. and Canada)
Distributed in Latin America by
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, 98-104
Carnarvon Street, Silverwater, NSW 2128, Australia Tel: Australia: (+61) 29
0371 388; New Zealand: 0800 142 101
Exported by
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon,
Hong Kong
www.bestwaycorp.com