I-TECH COMPANY NPW9240K-TCB Remove and Replace AD board and Inverter Instructions
- June 6, 2024
- I-TECH COMPANY
Table of Contents
I-TECH COMPANY NPW9240K-TCB Remove and Replace AD board and Inverter
Model: NPW9240K-TCB
Instructions
(1) Before your work, please make sure that the power is disconnected.
Step 1: Remove all the LCD panel screws (14 screws) then remove the LCD cover.
Step 2: Remove the LCD mounting screws (8 screws, 3 on each side, 2 on top).
Step 3: Lift up the panel and disconnect the LVDS & inverter wire slowly
and carefully for prevent the damage to both panel & wire, and remove the
panel set out of its chassis.
Step 4: Remove these 4 screws to release the AD board.
Step 5: Flip over the AD board and disconnect all the connected wires,
and then replace with new AD board.
~Follow the step backwrds to complete assembly the unit~
Documents / Resources
|
I-TECH COMPANY NPW9240K-TCB Remove and Replace AD board and
Inverter
[pdf] Instructions
NPW9240K-TCB Remove and Replace AD board and Inverter, NPW9240K-TCB, Remove
and Replace AD board and Inverter
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>