vevadent NZAOR 600 A2 Advanced Electric Toothbrush User Guide

vevadent NZAOR 600 A2 Advanced Electric Toothbrush

Online user instructions

Scanning this QR code takes you directly to the Lidl Service website (www .lidl-service.com), where you can enter the article number (IAN) 360218_2010 to open the online user instructions.

Items supplied

1. toothbrush 10
2. toothbrush heads 3
3. battery charger 12
4. travel ca s14
5.  quick reference guide

Intended purpose

The electric toothbrush is intended solely for tooth cleaning and oral hygiene in humans. The device is designed for private, domestic use. This device must not be used for com-mercial purposes.

Overview

1. Brush head
2. Indicator bristles
3. Toothbrush head (replaceable)
4. Marking ring
5. Peg of the toothbrush
6. LED: is lit white after switching on is lit red when pressure too high flashes red when the transport lock is switched on flashes 3x red when switching the transport lock on/off
7. On/off switch + transport lock for on and off switch
8. Function displays (illuminated):
9. Clean
10. Sensitive
11. Massage
12. Charging indicator light
13. Toothbrush
14. Peg of the battery charger
15. Battery charger
16. Mains power cable and mains plug
17. Travel case
18. Pressure cap

Instructions for safe operation

• This device can be used by children and people with restricted physical, sensory, or intellectual abilities or people without adequate experience and/or understanding, if they are supervised or instructed on how to use this device and if they are aware of the resulting hazards. Cleaning and user maintenance must not be performed by children unless they are supervised.
• Children must not play with the device.
• The battery charger is connected to the power voltage, and must therefore not be used in the shower, in the bath, or over washbasins filled with water.
• The main power cable of this device cannot be replaced. If the cable should become damaged, the device itself must be disposed of
• The battery must be charged only with the original accessory (battery charger) supplied.
• This device contains a battery that cannot be replaced.
• Protect the battery against mechanical damages. Fire hazard!
• Do not expose the device to direct sunshine or heat. The ambient temperature should not be lower than 10 °C or higher than 40 °C.
• Should the electrolyte solution leak out of the battery, avoid contact with eyes, mucous membranes and skin. Rinse immediately with plenty of clean water and consult a doctor. The electrolyte solution can cause irritation.
• The device is provided with a lithium-ion battery.
  • The battery cannot be removed!
  • This device must not be opened!
  • The device with the installed battery must be disposed of properly.
• The toothbrush, the battery charger, the main power cable, and the mains plug must never be immersed in water or any other liquids.
• Never touch the device with wet hands.
• If the battery charger has fallen into the water, pull out the mains plug immediately, and only then remove the battery charger from the water.
• If this happens, do not use the battery charger again until it has been checked by a specialist workshop.ter, pull out the mains plug immediately and only then remove the battery charger from the water. If this happens, do not use the battery charger again until it has been checked by a specialist workshop.
• The installation of a residual current de- vice with a nominal trip current not exceeding 30 mm in the building wiring offers additional protection. Contact a skilled electrician in this regard.
• Do not start using the device if the de- vice, the battery charger, or the mains power cable shows visible damage, or if the device has previously been dropped.
• In order to avoid any hazards, do not make modifications to the device. Re-pairs must be carried out by a specialist workshop or the Service Centre.

Charging the battery

1. Never set up the battery charger 12 anywhere it could fall into the water.

2. NOTES: Fully charge the battery before using it for the first time

3. It takes approx. 16 hours to fully charge the battery.

4. Plug the mains plug 13 of the battery charger 12 into a suitable wall socket. The wall socket must still be easily accessible after connection.

5. Place the switched-off toothbrush 10 onto the peg of the battery charger 11. The charging indicator light 9 flashes white throughout the entire charging process. Lit segments of the charging indicator light show the progress of the charging process. When the battery is fully charged, first all segments of the charging indicator light 9 are lit, and then they go out.

6. Battery signals: charging indicator light 9

7. Toothbrush 10 on the battery charger 12

8. All segments of the charging indicator light 9 are lit white and then go out: the battery is fully charged.

9. One or two segments of the charging indicator light 9 briefly light up white: the battery is being charged.

10. Toothbrush 10 switched on The charging indicator light 9 flashes red: the battery is weak. Charge the battery.

Toothbrush heads

The items supplied include 2 toothbrush heads 3. The various marking rings 4 allow you to assign the toothbrush heads 3 to different family members.

• Take a toothbrush head 3 and slide it onto the peg of the toothbrush 5.
• In order to remove, carefully pull the toothbrush head 3 off upwards.
• The indicator bristles 2 on the brush head 1 slowly lose their color during use. The decoloration shows when the toothbrush heads 3 should be replaced.
  NOTE: We recommend that you replace the toothbrush heads 3 every 3 months or after infections.

Operation

CAUTION

• Users could possibly experience mild bleeding of the gums during the first days of electric toothbrush usage. Should the bleeding continue over sev-eral days, a dentist should be consult-ed.
• If you have had dental surgery in the last two months, consult a dentist before using the toothbrush.
• Exert only light pressure when brushing
• to prevent damage to the gums and to increase the service life of the bristles.

Modes

The toothbrush 10 has 3 different modes. Depending on the desired mode, press the on/off switch  7 repeatedly when switched on, until the corresponding symbol is lit:

Clean mode

for cleaning teeth with high pulsation

Sensitive mode

gentle brushing for cleaning teeth with  sensitive gums
NOTE: if you are not used to using an electric toothbrush and you have comparatively sensitive gums, you can use this model for the first 1 to 2 weeks, and then switch to Clean mode later.

Massage mode

pulsating brushing to massage your  gums

Brushing teeth

•  Remove the toothbrush 10 from the battery charger 12.

•  Switch on the toothbrush using the on/off switch  7.

•  Press on/off switch  7 repeatedly until the function display 8 for the desired mode is lit.
  NOTE: switching over to another mode must be done quickly after the last button press of the on/off switch  7 (within approx. 1 second). Pressing the on/off switch  7 approx. 2 seconds after the last button press will switch the toothbrush off.

•  Switch off the toothbrush using the on/off switch  7.

•  Moisten the bristles, apply some tooth-paste, and only switch on the tooth-brush 10 again when the brush head 1 is already in your mouth.

•  Slowly guide the brush head 1 from tooth to tooth without exerting too much pressure. Carefully clean all tooth surfaces, the inner surfaces of the teeth and the tooth edges.
  Figure A: the recommended brushing time is at least 2 minutes, divided up into 30-second periods for each area of the mouth (bottom right, bottom left, top right, top left). The toothbrush 10 indicates these intervals by two brief interruptions.
  NOTE: if brush head 1 is pressed against the teeth too hard, the LED 6 lights up red. You should then reduce the pressure.

• The toothbrush signals the end of a cycle of 2 minutes with three short interruptions. Switch off the toothbrush using the on/off switch  7. Remove the brush head 1 from the mouth only when toothbrush 10 has been switched off.

Cleaning

For additional information on clean-ing and looking after the device and accessories, please see the online user instructions. To ensure the hygienic functionality of the toothbrush heads 3 they must be rinsed thoroughly after every use and al-lowed to dry.

Disposal

Packaging and device must be disposed of according to the environmental regulations of your country.

Trouble-shooting

If your device fails to function as required, please read the corresponding chapter in the online user instructions.

Technical specifications

Toothbrush
Protection class:| IPX4

(protected against water splashes)

Battery:| 1x 3.7 V  Li ion 600 mAh 2.22 Wh
Charging time:| 16 hours
Operating time:| __

approx. 90 min

Battery charger
Mains voltage:| 100 – 240 V ~ 50/60 Hz
Power rating:| 1.4  W Standby: 0.5 W
Protection class:| __

II

Protection class:| IPX7

(protected against the ef- fects of temporary immer- sion)

General
Dimensions:| approx. 38 x 190 x 29 mm (W x H x D)
Weight:| approx. 150 g
LEDs:| RG 0
Ambient condi- tions:| 10 °C to 40 °C

humidity 40 to 85% rela- tive

Symbols used

1. Double insulation
2. Geprüfte Sicherheit (certified safety). Devices must comply with the generally acknowledged rules of technology and the German Product Safety Act (Produkt-sicherheitsgesetz – ProdSG).
3. With the CE marking, HOYER Handel GmbH declares the conformity with EU guidelines.
4. This symbol reminds you to dispose of the packaging in an environmentally friendly manner.
5. Recyclable materials are marked with the recycling symbol (3 ar-rows). The material can be specified by the recycling number in the center (here: 21) and/or an abbreviation (here: PAP).
6. Direct current
7. AC voltage
8. It is a recyclable product that is subject to extended producer responsibility and for which the rules of waste separation apply.
   Subject to technical modifications..

Service Centre

If you require service, please contact our Service Centre:

Service Great Britain
Tel.: 0800 404 7657
E-Mail: hoyer@lidl.co.uk
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off-peak))
E-Mail: hoyer@lidl.ie
Service Cyprus
Tel.: 8009 4409
E-Mail: hoyer@lidl.com.cy
Service Malta
Tel.: 80062230
E-Mail: hoyer@lidl.com.mt

References

• de/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>