Nimbus Roxxane Leggera 52 CL LED Battery Table Lamp Instruction Manual
- September 3, 2022
- nimbus
Table of Contents
INSTRUCTION MANUAL
cableless LED desk and reading luminaires
http://www.nimbus-lighting.com/service/garantie
DEAR CUSTOMER,
Thank you for deciding in favor of the Roxane Leggera CL. This cableless LED
luminaire is a high-quality Nimbus product that combines highly efficient LED
technology with advanced battery technology, thereby representing a
breakthrough in the way we use light.
The following pages contain a few brief instructions to ensure that you gain
maximum pleasure from your new Roxxane Leggera CL and are able to exploit the
convenient functions such as touchless gesture control to the full.
GUARANTEE EXTENDED TO 3 YEARS!
Request free of charge within four weeks of the purchase date at: nimbus-
lighting.com/en/service/guarantee
THE ROXANE LEGGERA CL FAMILY
| 
---|---
Roxane Leggera 52 CL Desk luminaire| Roxane Leggera 101 CL Reading luminaire
LUMINAIRE COMPONENTS
- Sensor for gesture control
- 3D joint for rotating the luminaire head through 270 degree
- Handle
- USB-C charging port – for charging the luminaire with 5 V/max. 3 A
- USB-A “Roxxane Powerbank” port – for charging other devices such as smartphones or tablets with 5 V/max. 2 A
- LED display
- USB-C charging cable
- Nimbus Magnetic Dock for charging the luminaire with 24 V/2 A (optional accessory art. no.: 552-706)
- Lithium-ion rechargeable batter
GETTING STARTED
The luminaire is charged to around 40 – 60 % before leaving the factory and
can therefore be used as soon as it is removed from its packaging.
Before switching it on for the first time, you have to connect the luminaire
to a charging device (Magnetic Dock or USB-C) for a short time to deactivate
the battery’s transport protection.
ON – OFF
Pass your hand horizontally over the sensor at a height of 1 – 2 cm to switch the luminaire on or off.
DIMMING
Let your hand hover 1 – 2 cm above the sensor and the luminaire will slowly dim or brighten. The dimming direction changes with each switching procedure.
SLEEP MODE
If the luminaire is switched off, the economical Sleep Mode is activated after approx. 15 minutes. All functions remain active, but the sensor reacts more slowly to the next command. The next time the sensor is used, the luminaire returns to STANDBY MODE.
CHARGING
Roxane Leggera CL can be charged either using the Magnetic Dock (accessory –
not included in the scope of delivery) or using the USB-C port (USB-C charging
cable included).
The luminaire is charged to around 40 – 60 % before leaving the factory. We
recommend carrying out a full charging cycle in order to enjoy the full range
of performance.
PLEASE NOTE: Charge the battery before storing it for a longer period (3
months or longer).
Note on the charging procedure with the USB Power Adapter
If the charge capacity of the luminaire is < 10 % (as signaled by the flashing
red LED) and you wish to charge the luminaire with a USB-C power adapter, you
should switch the luminaire on and off again with the power adapter is
connected.
RESET
Note if the luminaire does not work: In this case, the luminaire requires a RESET: please loosen the screws on the bottom and remove the battery pack, wait a minute, then reinsert the battery pack and tighten the screws.
LED DISPLAY
The luminaire has 5 status LEDs that signal various states.
A Charge display
B Battery status display
C Boost Mode
CHARGE DISPLAY
This LED indicates whether and via which port the luminaire is being charged.
pulsing
| · The luminaire is being charged via the Magnetic Dock (luminaire can be
switched on during this time).
· The luminaire is being charged via the USB-C port (luminaire must be
switched off). The charging speed depends on the power adapter being used.
---|---
pulsing
| The luminaire is being run via the USB-C port.
Whether or not full luminous power can be provided depends on the power
adapter being used. With power adapters < 3 A, the luminaire dims down to the
max. attainable brightness/it cannot be dimmed up to the maximum brightness of
800 lumens.
off
| The luminaire is fully charged.
BATTERY STATUS DISPLAY
The 3 middle LEDs light up for 10 seconds to indicate the battery status.
The charge status is indicated by the number of LEDs that light up and in
which color, see graphics below.
Please note: The battery status display lights up for approx. 10 seconds every
time the luminaire is switched on or off, or dimmed. Exception: If the display
pulses permanently, the charge status is between 0 and 10 %.
pulsing
| 0 % – 10 % battery capacity
---|---
10 Sek / Sec
| 11 % – 20 % battery capacity
10 Sek / Sec
| 21 % – 40 % battery capacity
10 Sek / Sec
| 41 % – 80 % battery capacity
10 Sek / Sec
| 81 % – 100 % battery capacity
Alarm signal
10 Sek / Sec
| Battery faulty or missing
---|---
If all of the battery status display LEDs are pulsing, there is either no
battery in the luminaire or it is defective.
It must then be replaced – you will find more detailed information on p. 17 or
on our website. The luminaire will continue to work on the Magnetic Dock or
via a power supply at the USB-C port.
Please note: This alarm signal is only indicated for around 10 seconds
after the sensor has been activated.
BOOST MODE
When the lighting performance is between 400 and 800 lumens, the luminaire is in Boost Mode. The blue LED lights up solid to indicate this state. It signals the high lighting performance range and therefore higher power consumption. The range below Boost Mode, i.e. less than 400 lumens, is enough for normal use such as reading.
permanent
| Boost mode
---|---
POWER BANK PORT
The USB-A port can be used for charging other devices such as smartphones or
tablets.
The luminaire must have a large enough power supply to perform this task –
either through the battery or via the Magnetic Dock. The USB-A port is not
available as a power source when the luminaire is connected via the USB-C
port.
Please note: If power is provided via the battery, this has influence on
the luminaire’s available luminous flux. If the luminaire itself is used as a
power source, it will shine a little less brightly.
BATTERY PACK
The battery can be removed from its housing by loosening the two screws on the
bottom.
The luminaire will continue to work without its battery with power at the
Magnetic Dock or via a power supply at the USB-C port. In this case, the LED
indicators for the battery status display pulse red (see page 13).
SETTING THE POSITION OF THE LUMINAIRE
Please carry the luminaire by the handle only. Do not lift the Roxxane Leggera
CL by holding the luminaire head – this can cause damage.
The luminaire is equipped with a very maneuverable, long-life head joint made
of high-quality, untreated
pressure die-cast zinc. Please do not jerk the joint past the locking points.
Whenever possible, remove fingerprints and dirt immediately with a soft cloth.
WARNING NOTICES
****AMBIENT TEMPERATURE
The permitted ambient temperature for running this luminaire ranges from 0 ° C
to 40 ° C.
CAUTION: Always avoid direct sunshine and other heat sources!
HANDLING THE HIGH-PERFORMANCE LITHIUM-ION BATTERY PACK
DO NOT expose the battery pack to ANY mechanical stress; DO NOT drop or open. Make sure the ambient temperature is within the permitted range and ALWAYS avoid short-circuiting of the contacts caused by metal objects or fluids when the battery is outside of the luminaire.
ENVIRONMENTAL INSTRUCTIONS
The luminaire must not be disposed of with the household refuse at the end of
its life cycle. Take out the discharged battery and bring the luminaire and
the battery separately to your local disposal center for electrical and
electronic waste.
Nimbus Group GmbH
Sieglestraße 41
70469 Stuttgart · Germany
Tel. +49 (0) 7 11 63 30 14-0
Fax +49 (0) 7 11 63 30 14-14
www.nimbus-group.com
[email protected]
Nimbus and Rosso are
trademarks of the Nimbus Group.www.nimbus-group.com
04-2019 Art. Nr. 553-521