NANAMI M240 Fast Wireless Charger Stand User Manual

M 240
Fast Wireless Charger Stand
USER MANUAL

Website: www.nanarni.cc
Email: [email protected]

i phon
1. Metal or abnormal temperature detected 2. Using a non-Quick Charge Wall Charger|
USB – A|

If you want fast wireless charging and USB-A to be used simultaneously, Quick Charge 2.0 3.0 or 4.0 wall charger is highly recommended.USB-A port won’t provide power through a normal 5V adapter.

Attentions

• Please keep the charger away from water or other liquids.
• Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards, etc.) to avoid magnetic failure.
• This item is not to be used on any mobile device with metal plates, as it will cause extreme heat that may burn and/or damage the device.
• Fast charge via the plug and USB charging cable (both support QC 2.0 or QC 3.0).
• Usually, we recommend that the thickness of phone case should be within 3 mm (0.12 inch). It would not charge if the thickness is more than 5 mm (0.19 inches).
• The standard temperature of wireless charger QI is 130°F, but the temperature of our products should be controlled within 113°F. The charger will cut off the current when abnormal heating occurs. Please contact us if any damage occurs.
• We recommend that you turn off the power-consumption APP before charging to effectively prevent the phone from overheating. When the temperature exceeds 113°F during charging, it is normal for the charging speed to slow down.

FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to rovide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following. measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>