SAMSUNG SM-R500 Smart Watch Wireless Charger User Manual
- June 6, 2024
- Samsung
Table of Contents
SAMSUNG SM-R500 Smart Watch Wireless Charger
Smartwatch Wireless charger User Manual
- Enter the power parameter input voltage, 5. 0 ± 0. 5V input current on, lA
- Smartwatch wireless charger use steps: Put the smartwatch on the wireless charger wireless charger
- Put the smartwatch on the wireless charger
- The wireless charger is connected to the power adapter
- Plug the power adapter into the socket
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of the device, a distance of
15cm surrounding the device and 20 cm above the top surface of the device must
be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>