CLEANLIFE Smart LED Tape Light Instruction Manual
- June 6, 2024
- CLEANLIFE
Table of Contents
CLEANLIFE Smart LED Tape Light
Thank you for purchasing CLEANLIFE® Smart Lighting Product
WARNINGS:
- DO NOT put the controller around any metal or any device that could block the WiFi Signal.
- DO NOT power the tape light up until it is unrolled from the reel as it will overheat.
- Ensure that the connections are correct before powering up the device.
PLEASE READ CAREFULLY BEFORE INSTALLING YOUR DEVICE. Save these instructions, as you may need them at a later date.
what is in the box
INSTALLATION:
- Remove contents from the box. Ensure that no parts are missing.
- Plug the USB connector on the controller into the USB power adaptor.
- Connect the tape light to the other side of the controller. (Make sure to line up the arrows)
- WARNING: Make sure to unroll the entire tape light as it will overheat if it is powered on and still on the reel.
- Plug the controller into an outlet and power it on.
PRODUCT INFORMATION:
- USB 5V input connection.
- Output Connection to LED strip. (Make sure to line up the arrows)
- Button on Controller:
Functions:
a. On/Off, power on with one click, power off with two-shot clicks
b. Click to change between preset modes.
c. Long press for over 5 seconds to enter pairing mode.
TROUBLESHOOTING:
- Check that line voltage at fixture is correct.
- Ensure that there is voltage at light fixture wires. If there is no voltage, then check all connections.
- Check that fixture is grounded properly.
If the fixture does not light:
- Check switch to ensure that there are no defects.
- Check fuse/circuit breaker for trips, then check wiring connections.
CLEANING & MAINTENANCE:
CAUTION: Ensure fixture temperature is cool enough to touch. DO NOT clean or perform maintenance while fixture is energized.
- Clean lens and light fixture with a non-abrasive cleaning solution.
- Do not open fixtures to clean LED. Do not touch the LED.
- Do not spray liquid directly onto LED, LED driver or wiring.
3-YEAR LIMITED WARRANTY:
LIMITED WARRANTY: CLEANLIFE® Smart Light Fixtures are warranted to be free and clear of defects in materials and workmanship for a period of three years from the date of purchase. This warranty covers defects in manufacturing discovered while using the product as recommended by the manufacturer and does not apply to failures caused by acts of God or as a result of any abuse, misuse, abnormal use, or use in violation of any applicable standard, code, or instructions for use in installations. If a CLEANLIFE® LLC Light Fixture fails due to a defect covered by this warranty, CLEANLIFE® will, at its option, either replace the product or provide a credit equal to the current price CLEANLIFE® charges for the product. To make a warranty claim, retain the failed products and notify a CLEANLIFE® sales representative in writing within thirty (30) days of the failure.
CLEANLIFE® LLC
2165 East 33rd Street Cleveland, Ohio 44115
www.cleanlife.com
Technical Support Information
1-800-316-2532
Hours: 8:30am – 5:00pm Est (Monday – Friday)
CLEANLIFE® and the CLEANLIFE® mark are registered trademarks of Superior Ventures LLC. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>