PC-5783 Razer Hanbo AIO Cooler Instructions
- June 6, 2024
- Razer
Table of Contents
This video is a step-by-step process on how to install the Razer Hanbo AIO
cooler to your PC.
Let’s get started.
First, ensure that the Razer Hanbo AIO Cooler you have fits in your system.
The Razer Hanbo comes with either a 240 mm or 360 mm radiator, so get the one
that best fits your PC case.
Make sure to remove the piece of plastic covering the bottom of the cooler so
that it has direct contact with the processor.
Take care not to touch the bottom of the cooler, as it already comes pre-
applied with thermal paste.
Choose the appropriate mounting bracket for your CPU. Rotate the pre-installed
bracket counterclockwise to unlock and remove, or clockwise to hold it in
place.
Attach the backplate to the bottom of the motherboard if applicable, then
install the appropriate standoff screws into the motherboard.
Align the AIO cooler with the standoff screws then secures it using the
thumbscrew caps.
Install your Razer Kunai Chroma fans onto your radiator using the fan screws.
Mount the radiator inside the PC chassis then fastens it from the outside
using the washers and the radiator screws. Here are our recommended mounting
positions.
In general, ensure that the pump is at a lower position in the loop than the
radiator, so the air captured does not go back to the pump.
Link one of the fans to the 12-pin breakout cable using the 4-pin PWM
connector, and then link the other fans in sequence using the 3-pin connector.
Connect the USB Type-C cable and 12-pin breakout cable to your AIO cooler.
Attach the rest of the connectors to the CPU fan header and USB 9-pin header
of your motherboard and SATA cable from your power supply respectively.
Use Razer Synapse to access the fan and pump speed adjustments, as well as
lighting customization options.
There you have it, you’ve successfully installed the Razer Hanbo AIO cooler to
your PC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>