tuya C3-1B Smart Light User Manual

tuya C3-1B Smart Light User Manual

Download APP

Search “Tuya Smart” on the App Store (for iPhones), Google Play (for Android phones), download and install it, then create an account as prompted.

Preparation for Use

WiFi Light

• Make sure that the mobile phone, smart light, and router are close to each other.
• Turn on the smart light and make sure that the phone is connected to the 2.4GHz Wi-Fi network.

*Note: It needs to be operated in a 2.4GHz network environment, and 5G networks are not supported currently. If your Wi-Fi is 5G, please set it to 2.4GHz first. Please refer to the router manual for specific methods.

Bluetooth Light

Ensure that the mobile phone is close to the smart light and turn on the Bluetooth of the mobile phone.

Add Device

Click “Add Device” to enter the manual add page, and select the corresponding product in the “Lighting” list.

Set up the network

Select the 2.4GHz Wi-Fi network, enter the password, and follow the prompts to connect to the device.5G network is not supported temporarily. If your Wi-Fi is 5G, please set it to 2.4GHz first. Please refer to the router manual for the specific method.

Reset the device

If the smart light flashes, you can skip the reset steps and go to the next step. If the smart light is always on, please reset it according to the following method and try to connect again.

How to reset?

1. Use the switch to turn off the smart light first.
2. Use the switch to turn on and off 3 times, the steps are as follows: ON-OFF-ON-OFF-ON.
3. After waiting for a few seconds, the smart light starts to flash, which means the reset is successful.

Download App

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC warning

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

IC warning

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>