EVALOGIK ZW12 Z-Wave Multi Relay Instructions
- June 6, 2024
- EVALOGIK
Table of Contents
EVALOGIK ZW12 Z-Wave Multi Relay
Features
- Z-wave with chip 700
- 2 relays NO/NC, 30A1, 20A1
- Inputs : here are new requirements. Each input has 4 terminals : Sw, C, C and V. Coils should be activated with SW-C closing circuit ( regular switch ) or any sensor with resistance below 50k Ohm .
- Two inputs will not exist at the same time.
- OTA function
- S2&SmartStart
- Indoor use
Terminal label
Wiring
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.