TapTop BPTT01 Alexa Built-in Founders Edition User Manual
- June 6, 2024
- TapTop
Table of Contents
Product Manual
Model Number: BPTT01/A
Electrical Rating 12.0V, 5.0A (60W)
Operating Ambient Temperature: 0°C – 40 °C
Storage Temperature: -20°C – 60°C
Relative Humidity: Up to 85% non-condensing
Safety Information
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY, OR
DAMAGE TO YOUR DEVICE
Important Product Information
Positioning the Device
If your device falls and hits someone, especially a small child, it could cause serious injury. To reduce the risk of such injuries and damage to the device, set up the device according to these instructions.
Place the device on a surface that:
- Is flat and level.
- Is stable and not likely to tip over.
- Allows all four rubber feet of the device to be in contact with the surface.
- Is not likely to allow the device to slip or slide off.
- Is clean and free of dust and debris.
Cables
Arrange all cables and cords so that people and pets are not likely to trip over or accidentally pull on them as they move around or walk through the area When the device are not in use, you may need to disconnect all cables and cords from the device to keep them out of the reach of children and pets. Do not allow children to play with cables and cords.
Preventing the Device from Overheating
Your device requires proper ventilation. When in use, do not cover with materials such as newspapers, tablecloths, or curtains. Do not use the device on soft support such as bedding, blankets, etc. Allow ventilation space of at least 10cm on the top and side of the device Do not place the device in an enclosed cabinet space without sufficient ventilation. Do not place the device near any heat sources such as radiators, heat registers, stoves, etc.
Electrical Safety
Use only the power adapter unit and AC power cord that came with the device. Confirm that your electrical outlet provides the type of power indicated on the power adapter unit (in terms of voltage [V] and frequency [Hz]). Do not overload your wall outlet, extension cord, power strop, or other electrical receptacle. Do not connect any other devices between the power adapter unit and the device.
Do Not Attempt Repairs
Do not attempt to take apart, open, service, or modify the device and the power adapter unit. Any evidence of any attempt to open and/or modify the device, including peeling, puncturing, or removal of any of the labels, will void the Limited Warranty and render the device ineligible for authorized repair.
Product Specifications
FCC Compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC Caution:
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules
The party responsible for FCC compliance is Blok.Party, Inc. 2268 Westborough Blvd, Suite 302 #414, South San Francisco, CA 94080.
Industry Canada Statement (CAN ICES-3 (B)/NMB-3(B))
This device complies with ISED s licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
greater than 20cm between the radiator & your body.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
European Union Directives Conformance Statement
Blok Party, Inc. hereby declares that this wireless device is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: blokparty.com/compliance
European Union Safety Information
Wireless Specifications and Declared maximum RF Power:
2.4GHz: 16.73dBm
5GHz B1: 14.32dBm
RF Exposure Statement:
This device has been tested and meets applicable limits for Radio Frequency
(RF) exposure.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
The device is restricted to indoor use only when operating in the 5150 to 5250 MHz frequency range.
Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product, it means the product is covered by the European Directive 2012/19/EU. Please find out for yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.
AT
| BE| BG| HR| CY| CZ| DK
---|---|---|---|---|---|---
EE
| FI| FR| DE| EL| HU|
IE
IE
| LV| LT| LU| MT| NL|
PL
PT
| RO| SK| SI| ES| SE|
UK
IS| LI| NO| CH| TR|
|
Limited Warranty
Your device is covered by a Limited Warranty. Details are available at BlokParty.com.
Customer Support
For answers to common questions, troubleshooting steps, and Blok Party Customer Support contact information, visit BlokParty.com/support.
