Alliance 205131 NFC USB Control User Manual
- June 6, 2024
- Alliance
Table of Contents
Alliance 205131 NFC USB Control User Manual
COMPLIANCE STATEMENTS
PRODUCT COMPLIANCE
Users of this product are cautioned not to make modifications or changes that are not approved by Alliance Laundry Systems, LLC. Doing so may void the compliance of this product with applicable laws and regulatory requirements and may result in the loss of the user’s authority to operate the equipment.
UNITED STATES
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the radio or television receiving antenna.
- Increase the separation between the computer equipment or receiver.
- Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
- Consult the dealer or experienced radio television technician for help.
CAUTION: To comply with the limits of the Class B device, pursuant to Part 15 of the FCC Rules, this device is to comply with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables is likely to result in interference and reception of the device.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrol ed environment.
The radio installed in this equipment and is intended to operate with minimum distance 20cm between the radiator and your body.
Limited Channels Fixed – USA: IEEE 802.11b or 802.11g or 802.11n(HT20) operation of this product in the U.S. is firmware-limited to Channel 1 through 11.
CANADA (Canadian French)
CAN ICES-3(B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s) standards. Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement: This equipment complies with Innovation, Science and Economic Development Canada’s radiation exposure limits set forth for in RSS-102. The radio installed in this equipment is installed and is intended to operate with minimum distance 20cm between the radiator and your body.
California Proposition 65 (The Safe Drinking Water and Toxic Enforcement Act, 1986)
Canadian Prohibition of Certain Toxic Substances Act SOR/2012-285
EUROPE (Req’d Languages)
Products bearing the CE mark comply with the following EU directives:
- EMC Directive 2014/30/EU
- Low Voltage Directive 2014/35/EU
- RoHS Directive 2011/65/EU and its amendment directives; Commission Delegated Directive 2015/863 to restrict four phthalates
- REACH Regulation 1907/2006 and its amendment regulations
- POP Regulation 850/2004 and its amendment regulations
If the product has telecommunications functionality, it also complies with the requirements of the following EU directive:
Radio Equipment Directive 2014/53/EU
Compliance with these Directives implies conformity to harmonized European
standards that are noted in the EU Declaration of Conformity which is
available upon request.
Alliance Laundry Systems products comply with the requirement of Article 12 as
it can be operated in at least one Member State as examined and the product is
compliant with Article 11 as it has no restrictions on putting into service in
all EU member states.
This device contains a 2.4GHz transceiver, intended for indoor use only in all
EU member states, EFTA states, and Switzerland.
Attention has been given to allowed operational frequencies. For detailed
information concerning installations in France, the user should contact the
national spectrum authority in France http://www.arcep.fr/
Be aware that outdoor installations require special attention and will only be
handled by trained and qualified installation personnel.
No one from the general-public is permitted to install wireless products
outdoors when external antennas, power and grounding must be installed for
use.
Any approvals for countries not represented in this document will be provided on request.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>