PegPerego NA-FINA2401I157 Zero 3 Prima Pappa Little Folks Instruction Manual
- June 4, 2024
- PegPerego
Table of Contents
PegPerego NA-FINA2401I157 Zero 3 Prima Pappa Little Folks
Product Specifications
- Product Name: Prima Pappa Zero-3
- Recommended Age: From birth up to 6 months or 20 lbs (9 Kg)
- Reclining Positions: 5 positions
- Footrest Positions: 3 positions
Product Usage Instructions:
Important Safety Instructions
- Never leave the child unattended; always keep the child in view while in the highchair.
- Always use the highchair on a flat, horizontal surface.
- Use restraint system at all times.
- Avoid placing the child near safety hazards such as electrical cords, sources of heat, or flames.
Assembly and Operating Procedures
- All assembly and operating procedures should be performed by an adult.
- Do not use the product if it has broken or missing parts.
- Avoid placing fingers in the mechanism.
Product Usage Guidelines
- Use the high chair in the recliner or upright position only by children capable of sitting upright unassisted.
- The recliner is not designed for long periods of sleep; use a suitable cot for sleeping.
- Adjust the footrest and reclining backrest as needed for comfort.
Cleaning and Maintenance
- Regularly clean the high chair following the manufacturer’s instructions.
- Check for any loose parts or signs of wear and tear regularly.
Frequently Asked Questions (FAQ):
-
Q: Can I use accessories not approved by the manufacturer with the high chair?
A: No, using accessories that have not been approved by the manufacturer may be hazardous and should be avoided. -
Q: Can the high chair be used as a substitute for a cot for sleeping?
A: No, the high chair is not designed for long periods of sleep and should not be used as a substitute for a cot. Use a suitable cot for sleeping purposes.
Thank you for choosing a PegPerego product.
WARNING
- IMPORTANT : READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD PUT THE CHILD’S SAFETY AT RISK.
- ALL ASSEMBLY AND OPERATING PROCEDURES SHOULD BE PERFORMED BY AN ADULT; DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
WARNING
- FALL HAZARD: CHILDREN HAVE SUFFERED SEVERE HEAD INJURIES INCLUDING SKULL FRACTURES WHEN FALLING FROM HIGH CHAIRS. FALLS CAN HAPPEN SUDDENLY IF CHILD IS NOT RESTRAINED PROPERLY.
- ALWAYS USE RESTRAINTS, AND ADJUST TO FIT SNUGLY.
- TRAY IS NOT DESIGNED TO HOLD CHILD IN CHAIR.
- STAY NEAR AND WATCH CHILD DURING USE.
WARNING
- THE CHILD SHOULD BE SECURED IN THE HIGH CHAIR AT ALL TIMES BY THE RESTRAINING SYSTEM, EITHER IN THE RECLINED OR UPRIGHT POSITION.
- TRAY IS NOT DESIGNED TO HOLD THE CHILD IN THE CHAIR.
- IT IS RECOMMENDED THAT THE HIGH CHAIR BE USED IN THE UPRIGHT POSITION ONLY BY CHILDREN CAPABLE OF SITTING UPRIGHT UNASSISTED.
- TRAY AND ACCESSORY TRAYS ARE NOT DESIGNED TO SUPPORT THE CHILD’S WEIGHT.
- ALWAYS USE THE CROTCH STRAP.
- NEVER LEAVE THE CHILD UNATTENDED; ALWAYS KEEP CHILD IN VIEW WHILE IN THE HIGHCHAIR.
- NEVER LEAVE THE BABY ALONE WITHOUT SUPERVISION.
- ALWAYS USE THE HIGHCHAIR ON A FLAT, HORIZONTAL SURFACE.
- BE CAREFUL OF WHERE YOU PLACE THE PRODUCT. AVOID PLACING THE CHILD NEAR SAFETY HAZARDS SUCH AS ELECTRICAL CORDS, SOURCES OF HEAT, OR FLAMES.
- DO NOT PUT FINGERS IN THE MECHANISM. MAKE SURE YOUR CHILD’S ARMS AND LEGS ARE CLEAR OF THE MOVING PARTS DURING ADJUSTMENT.
- USING ACCESSORIES THAT HAVE NOT BEEN APPROVED BY THE MANUFACTURER MAY BE HAZARDOUS.
- DO NOT USE THE PRODUCT NEAR STAIRS OR STEPS.
- BE CAREFUL NOT TO PLACE THE PRODUCT NEAR SOURCES OF HEAT OR FLAMES, SUCH AS GAS STOVES, ELECTRIC HEATERS, ETC.
- KEEP THE HIGH CHAIR WITH THE BABY FAR FROM STOVES, STAIRS AND WARMING DEVICES.
- MAKE SURE THE BELT IS ATTACHED PROPERLY.
- DO NOT USE THE HIGH CHAIR UNLESS ALL OF THE PARTS ARE PROPERLY FITTED AND ADJUSTED.
- TO MAKE SURE THAT ANY HARNESS IS CORRECTLY FITTED.
- NEVER CARRY THE HIGH CHAIR WITH THE BABY INSIDE.
RECLINER
- WHEN USED AS A RECLINER, THIS PRODUCT IS DESIGNED FOR CHILDREN FROM BIRTH UP TO 6 MONTHS OR 20 lbs (9 Kg).
- DO NOT USE THE PRODUCT AS A RECLINER WHEN THE CHILD IS ABLE TO SIT UP ALONE.
- THE RECLINER IS NOT DESIGNED FOR LONG PERIODS OF SLEEP. IT SHOULD NOT BE USED AS A SUBSTITUTE FOR A COT. IF THE CHILD NEEDS TO SLEEP, HE/SHE SHOULD BE PLACED IN A SUITABLE COT.
- DANGER OF STRANGULATION: NEVER LEAVE THE CHILD IN THE RECLINER IF THE SAFETY HARNESS IS LOOSE OR UNDONE.
- RISK OF FALLING: IT IS DANGEROUS TO USE THE RECLINED CRADLE ON A RAISED SURFACE.
- A single product which follows the growth of your child.
- From 0 to 6 months, a comfortable reclined cradle;
- From the age of 6 months, a high chair for eating, playing and relaxing.
- From the age of 12 months, a high chair without a tray, for sitting at the table with the adults.
- The images referring to the textile details may differ from the collection purchased.
For more information, consult our website: www.pegperego.com
INSTRUCTIONS FOR USE
-
FITTING THE FRONT AND REAR WHEELS: fit the two front wheels to the front of the high chair (fig_a) and the rear ones, with the brake, to the rear (fig_b), by pushing in the direction of the arrow.
-
OPENING: Lift the seat (fig_a), press the side buttons (fig_b) and open the high chair (fig_c).
-
BRAKE: the rear wheels of the high chair are fitted with brakes. To apply the brakes, lower the levers on the rear wheels. To release them, raise the levers. It is recommended that you apply the brakes before carrying out any procedures involving the high chair.
-
TRAY: To fit the tray, pull the central lever underneath it towards you while at the same time pushing it all the way into the armrests (fig_a). To extend or remove the tray, pull the central lever underneath it towards you (fig_b) and move it outwards (fig_c). To remove the tray, pull the side levers outwards and pull the tray towards you. The high chair has a double tray. The top tray can be easily washed in a dishwasher. To remove it, detach it from the lower tray and lift it up (fig. d).
-
ADJUSTING THE HEIGHT: The chair can be set at 7 different heights. To raise or lower the chair, press the two side levers (fig_a) and stop in the required position. The handle under the netting can also be used to raise the seat (fig_b). The height can be adjusted in these ways with the child in the high chair.
RECLINING BACKREST: The seat can be reclined in 5 positions. To adjust it, raise the handle behind the backrest (fig. c) and lock it in the required position. This can also be done with the child in the high chair.
-
ADJUSTABLE FOOTREST: The footrest can be set in 3 positions. To raise it, push it upwards. To lower it, push in the two levers and move the footrest down (fig_b).
-
FIVE-POINT SAFETY HARNESS: To fasten the safety harness, push the two waist strap buckles (with the shoulder straps attached) into the leg divider until they click into position (fig_a). To release it, press the center of the buckle while pulling the waist strap outwards (fig_b). To tighten the waist strap, pull the ends on both sides. To loosen it, do the opposite.
-
The shoulder straps of the harness can be set at two different heights. Partially remove the fabric covering (fig_a), release the shoulder straps from the backrest (fig_b) and pull them out from the fabric covering. Insert the ends of the shoulder straps in the other slots in the fabric covering and the backrest (fig_c), then put the fabric covering back into the right position on the backrest.
-
USE WITHOUT THE TRAY: to use the seat at the table, remove the tray. To clip the tray on the rear supports of the high chair, align and engage it with the attachments (fig_b).
-
CLOSING AND REOPENING THE TRAY: Pull the central lever underneath the tray towards you (fig_a) and extend it as far as the red markers (fig_b), then swing it upwards to lock it in place (fig_c). To reopen the tray, press the lever under the armrest (fig_d), swing it downwards, then pull the central lever towards you and put the tray in one of the positions for use.
-
FOLDING UP: Press the side buttons (fig_a) and fold up the high chair (fig_b). Fig_c shows a folded-up high chair. For greater stability when folded, ensure the wheels are rotated outwards (fig_d).
-
REMOVABLE COVERS: To remove the covers of the seat, pull off the upper part of the fabric covering and pull the harness straps through the backrest (fig_a) and the fabric covering (fig_b). Lower the backrest and pull out the leg divider strap from under the seat (fig_c).
-
Unbutton the sack at the sides (fig. a) and pull up to remove it (fig. b).
THE ORIGINAL ACCESSORY PEGPEREGO
PegPerego accessories are designed as a useful, practical means of simplifying the lives of parents. Discover all your product’s accessories on: www.pegperego.com
SERIAL NUMBERS -
Information about the production date of the Prima Pappa Zero-3 can be found on the seat.
_ Product name, date of manufacture and serial number.
This information is required for any complaints.
CLEANING AND MAINTENANCE
Cleaning must only be carried out by adults.
PRODUCT MAINTENANCE : protect from the weather: water, rain, or snow;
prolonged and continuous exposure to bright sunlight may give rise to colour
changes of various different materials; store this product in a dry place.
CLEANING
T HE CHASSIS : periodically clean all plastic parts with a damp cloth. Do
not use solvent or similar cleaning products; keep all metal parts dry to
prevent rusting; keep moving parts clean (adjustment mechanisms, locking
mechanisms, wheels, …) and free of dust and sand and, if necessary, lubricate
with light machine oil.
CLEANING
THE SACK : Wash with a damp cloth and neutral detergent.
- When washing, closely follow the instructions stated on the label sewn into the cover.
- Do not use chlorine bleach.
- Do not iron.
- Do not dry clean.
- Do not remove stains with solvents.
- Do not tumble dry.
PEGPEREGO S.p.A.
PegPerego can make changes at any time to the models described in this
publication for technical or commercial reasons. PEGPEREGO AFTER-SALES SERVICE
If any parts of your PegPerego product should be accidentally mislaid or
damaged, use exclusively genuine original PegPerego replacements. For any
repairs, replacements, product information, and orders for genuine original
replacement parts and accessories, contact PegPerego After-Sales Service: USA
Call Peg Perego Customer Service
1-800-671-1701 or visit
www.pegperego.com
CANADA
Customer Service 1-800-661-5050
or visit www.pegperego.com
Declaration of conformity
- Product name: PRIMA PAPPA ZERO-3
- Product reference number: IMPP03NA
- Reference Standards (origin): ASTM F 2088-08a ASTM F 404-18, 16 CFR 1501, 16 CFR 1303, CPSIA 2008
- Declaration of conformity La PegPerego S.p.A. dichiara sotto la propria responsabilità che l’ articolo in oggetto è stato sottoposto a test di collaudo interni e omologato secondo le normative vigenti presso laboratori esterni ed indipendenti.
- Date and place of issue: Arcore, May 2019 PegPerego S.p.A. Via De Gasperi, 50 20862 Arcore (MB), ITALY
PEG PEREGO S.p.A.
VIA DE GASPERI 50 20862 ARCORE MB ITALIA
tel. 0039 039 60881
Servizio Post Vendita – After Sale:
tel. 0039 039 6088213
PEG PEREGO U.S.A. Inc.
3625 INDEPENDENCE DRIVE FORT WAYNE INDIANA 46808 Call us toll free: 1 800 671
1701
PEG PEREGO CANADA Inc.
585 GRANITE COURT PICKERING ONTARIO CANADA L1W3K1 Call us toll free: 1 800 661
5050
www.pegperego.com
WARNING
AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS USE COMPLETE 5 POINT
SEAT BELT.
All of the intellectual property rights for the contents of this instruction manual belong to Peg Perego S.p.A. and are protected by the laws in force.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>