Anhui Inno Sign 240602 Magnetic Wireless Charger Instruction Manual
- June 6, 2024
- Anhui Inno Sign
Table of Contents
Anhui Inno Sign 240602 Magnetic Wireless Charger
PRODUCT OVERVIEW
- Wireless charging surface
- Type C Input port
- Cable
SPECIFICATION
- Input: 5V/2A, 9V/1.5A
- Output: 5W, 7.5W, 10W
Instructions
Connect the Type-C input to a power source, Place the wireless charging
supported mobile device on the wireless charging surface. Phone will begin to
charge automatically , once fully charged remoce the device
if your wireless charging compatible device contains magnets, it would just click to the wireless charging surface for better alignment to secure wireless charging.
IMPORTANT:
- Only use included accessories or certified and tested accessories to charge this device. Using third party accessories can influence the item safety.
- Some phone cases may block the wireless charging
- Do not place other materials, like metal objects, magnets, and magnetic stripe cards, between the mobile device and the wireless charger pad.
- Check your mobile device’s battery percentage using the charging icon displayed on the screen of your phone.
- When the mobile device is not placed on the charging surface accurately, your mobile device may not charge properly.
- Never Store or Use this product in temperatures below 32°F(0°C) or above115°F(45°C).
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment shall be installed and operated with
minimum distance 20cm between the radiator & body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>