Anhui Inno-Sign International Co Ltd 2800-58 Walton Wireless Charging Journal Book Instruction Manual
- June 1, 2024
- Anhui Inno-Sign International Co Ltd
Table of Contents
International Co Ltd
Instruction Manual
2800-58 Walton Wireless Charging Journal Book
- Charging Pad*
- Micro-USB power input
*functions only with inductive charging compatible devices
SPECIFICATIONS:
USB Input: 5V/2A
Wireless Output :5W
INSTRUCTIONS:
Powering the inductive charging surface:
Insert provided Micro-USB charging cable into power input port.
Insert the USB end of the cable into a certifed USB AC adapter, USB port of a
computer or power bank to supply power to the device.
NOTE: This device does not contain a battery. Power must be providedto the
charging pad to function as described.
SAFETY PRECAUTIONS:
WARNIING-When using this product, basic precautions should always be
followed, including the following:
Read all the instructions before using the product.
To reduce the risk of injury, close supervision is necessary when the product
is used near children.
Do not expose the device to moisture.
Do not use the device in excess of its output rating, Overload outputs above
rating may result in a risk of fre orinjury.
Do not use the device if damaged or modifed.
Damaged or modifed batteries may exhibit unpredictable behavior resulting in
fre, explosion or risk of injury.
Do not disassemble the device. Take it to a qualifed service person when
service or repair is required incorrectreassembly may result in a risk of fre
or injury.
Do not expose the device to fre or excessive temperature. Exposure to fre or
temperatures above 212°F may cause explosion.
Have servicing performed by a qualifed repair person using only identical
replacement parts.
Avoid overheating: Do not place anything between the phone and the charger
especially magnetic devices.
FCC Statement:
This device complies with part 15 of the FCC Rules, Operation is subject to
the following two conditions.(1)
This device may not cause harmful interference, and (2) this device must
accept any interferencereceived, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radiofrequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment shall be installed and operated with
minimum distance 20cm between the radiator & body.
WWW.PCNA.COM
Leedsworld Inc 400 Hunt Valley Road, New Kensington, PA 15068 USA.
© 2019 LEEDSWORLD Proprietary information contained in this drawing is the
sole property of Leedsworld.
Any reproduction in part or as a whole without the written permission of
Leedsworld is prohibited.
www.fsc.org
MIX
Paper I Supporting responsible forestry
FSC® C170910
FCC ID: 2ANFN2800-58
Made in China
Walton Wireless
Charging Journal Book
Item: 2800-58