ThemoEye M6 Non Contact Visual Face Capture Temperature Measuring User Manual
- June 6, 2024
- ThemoEye
Table of Contents
ThemoEye M6 Non Contact Visual Face Capture Temperature Measuring
- Please connect the temperature probe to the tablet or mobile phone according to the installation process picture.
- Please use the product according to the app operating instructions.
Installation guide
Tablet Figure of the overall installation with the temperature probe
APP
LED Indicator
Normal operation (blue light flashing / once every 3 seconds)Bluetooth pairing
(fast flashing red and blue)
- After the “ThermoEye” is powered on, the blue LED on the front of the probe will flash.
- Open the app and the LED on the front of the “ThermoEye” will flash quickly(representing Bluetooth pairing). After pairing, the blue LED will flash once every three seconds.
- At this time, the app interface should instantly display “connected” for further operation.
- Refer to the app icon key description table in the key table for related key operation.
- Enter the Real time face temperature measurement page please click the “ Camera ICON”。
When the face image enters the recognition frame, it will not move any more; the temperature test can be displayed in about one second Numerical value and voice play. If it is not set to the identification box, it will remind you to enter the identification box.
Real time face temperature measurement and photographing
Upload or share the photos which has already been captured and saved
Setting page
- Switch temperature mode between centigrade and Fahrenheit
- Temperature range of abnormal body temperature
- Temperature range of abnormal temperature voice alarm
Support multi language setting
Application scenarios
- office / factory / restaurant / School
- buses / subways and other means of mass transit
FCC Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>