AiNSTEiN WAYV Pro Building Automation and Lot Suppliers Instruction Manual

AiNSTEiN WAYV Pro Building Automation and Lot Suppliers

Installation

The radar azimuth has the DBF angle measurement capability, the pitch is a narrow beam and does not have the angle measurement capability, the plane shown is the antenna plane
The default installaNon orientaNon of the radar is as follows:

Take the cross bar as an example, the installaNon steps are shown in Figure 1~4:

1.  Confirm the installaNon posiNon and place the installation bracket horizontally on the crossbar;
2. Confirm the diameter of the crossbar, select the appropriateclamp, and use a screwdriver or sleeve to fix the clamp Nghtly. The bracket uses 3 clamps;
3.  Use 4pcs M5x20 three combinaNon screws to fix the radar equipment on the bracket, please pay special a]enNon to the posiNon of the radar equipment;
4.  Adjust the le_, right and pitch angles of the stand according to the actual scene.

•  In order to minimize the interference from the ground to the radar, it is recommended that the installaNon height is not less than 5m, and there should be no strong obstrucNons such as people, buildings, metal poles, etc. within 20m.
•  The radar antenna is facing the observaNon direcNon, and it can be placed horizontally. The installaNon must ensure that the radar is not significantly upturned, otherwise it will seriously affect the performance of the radar
•  After normal power-on, about 6s, the normal state of the 4 lights on the radar antenna surface is:
  •  POW: Flashing every 5s
  •  RUN: The blinking speed is very fast with the naked eye at an interval of about 250ms ALM1: Always on
  •  ALM2: flashes at intervals of about 1s
  •  If the flashing light changes significantly, it can be judged to be abnormal, and it is recommended to contact our company for confirmaNon .

Software and hardware have complete independent intellectual property rights.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>