ECODHOME 01335 Inline Switch and Power Meter Installation Guide

: June 6, 2024
: EcoDHOME

Table of Contents

Introduction
Product description and specification
Installation
Operation
Limited warranty
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Inline switch and power meter installation Manual

ECODHOME 01335 Inline Switch and Power Meter .

Introduction

Thanks for choosing the Smarthome inline switch and power meter for pairing with the home automation gateway. This module is a Z-Wave-enabled device and is fully compatible with any Z-Wave-enabled network. Every mains-powered Z-Wave enabled device acts as a signal repeater and multiple devices result in more possible transmission routes, which helps eliminate “RF dead-spots”.
The device is a Z-Wave appliance switch, which can report wattage energy usage or kWh energy usage to a Z-Wave gateway. It can also be controlled by other Z-Wave devices, to turn on/off when appropriate. This device also acts as a repeater.

Product description and specification

For indoor use only.
Specification
Protocol: Z-Wave.
Frequency range: 868.42 MHz.
Operating range: 30 m uninterrupted.
Power supply: 230 Vca mains.
Measurement: Watts or kWh.
Maximum power connected: 2990 W or 13 A.
Degree of protection: IP20.
Operating temperature: -20°C to +82°C.
Package contents
1 inline switch and power meter.
1 Installation manual.

Installation

On the device, there is a button that is used to carry out the inclusion, exclusion, or association.
To put a Z-Wave wireless controller into inclusion/ exclusion mode, press the button once.

ECODHOME 01335 Inline Switch and Power Meter -
Installation

Note: if the device was correctly removed from the ZWave network, the Status Indication LED will be blinking.

Operation

As soon as the inline switch is connected to the appliance you want to control, the LED indicator will be solid on and the device detects and transmits the consumption data (W or kW) or it can activate the rules defined by the Z-wave home automation gateway.
If this function is supported by the Z-Wave gateway to which it is paired, energy consumption data will be available on the user interface.
Note: if the device is not successfully included in the Zwave network, the LED will blink slowly.

Warning
Do not dispose of electrical appliances along with general waste, use separate collection facilities.
Contact your local council for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater damaging the environment and human health.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposal free of charge.