Litever Remote LED Dimmer Switch 12VDC 3A User Manual
- June 6, 2024
- Litever
Table of Contents
Litever Remote LED Dimmer Switch 12VDC 3A
Product Description
This remote LED dimmer is designed to work together with Litever 12VDC under cabinet light strips or other 12VDC LED lighting products. The dimmer is based on PWM technology. And it’s based on RF technology for remote control.
Product Specification
- Input: 12VDC Maximum
- Output: 12VDC,3A, 36W
How to use
- 12VDC power input here. Input power connector shall be DC 5.5mm x 2.1mm male.
- 12VDC LED lights here. LED lights shall be with DC 5.5mm x 2.1mm female connector.
Remote
When pressing and simultaneously, the LED lights will flash. To stop that, press the 2 keys simultaneously again.
Important Notice
- Caution: There is 1 unit 27A 12V alkaline battery inside the remote control. When the battery runs out, pls replace the battery. The battery is NOT rechargeable. Pls do NOT recharge the battery. Pls, do NOT put the battery on fire or open the battery. Caution: Pls protect the LED dimmer/remote control from the electrical short circuit. Other it will be damaged. Pls power the controller with 12VDC only. Otherwise, the LED
- Caution: dimmer will be damaged. This LED dimmer is NOT waterproof. It’s for indoor usage ONLY. Caution: This LED dimmer may be NOT compatible with other LED dimmers.
- Caution: Pls use only one LED dimmer for one serial run.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>