TEGERA 9902 Synthetic Leather Glove Instruction Manual
- October 27, 2023
- TEGERA
Table of Contents
TEGERA 9902 Synthetic Leather Glove
Carefully read these instructions before using this product.
DECLARATION OF CONFIRMITY
www.ejendals.com/conformity
EXPLANATION OF PICTOGRAMS 0 = Below the minimum performance level for the
given individual hazard X= Not submitted to the test or test method not
suitable for the glove design or material
Warning
This product is designed to provide protection specified in PPE Regulation
(EU) 2016/425 with the detailed levels of performance presented below.
However, always remember that no item of PPE can provide full protection and
caution must always be taken when exposed to risks.
- A. Abrasion resistance Min. 0; Max. 4
- B. Blade cut resistance Min. 0; Max. 5
- C. Tear resistance Min. 0; Max. 4
- D. Puncture resistance Min. 0; Max. 4
- E. Cut Resistance TDM Min. A; Max.
- F. Impact Protection P=Pass
PROTECTIVE GLOVES AGAINST MECHANICAL RISKS. Protection levels are
measured from area of glove palm.
Warning:
For gloves with two or more layers the overall classification of EN 388:2016
does not necessarily reflect the performance of the outmost layer. Do not use
these gloves near moving elements or machinery with unprotected parts. For
dulling during the cut resistance test, the coupe test results are only
indicative while the TDM cut resistance test is the reference performance
result.
- The glove is shorter than a standard glove, in order to enhance the comfort for special purposes – for example fine assembly work.
GENERAL REQUIREMENTS AND TEST METHODS
Finger dexterity test: Min. 1; Max. 5
FITTING AND SIZING: All sizes comply with the EN 420:2003+A1:2009 for
comfort, fit and dexterity, if not explained on the front page. If the short
model symbol is shown on the front page, the glove is shorter than a standard
glove, in order to enhance the comfort for special purposes – for example fine
assembly work. Only wear the products in a suitable size. Products which are
either too loose or too tight will restrict movement and will not provide the
optimal level of protection.
STORAGE AND TRANSPORT
Ideally stored in dry and dark condition in the original package, between +10º – +30ºC.
INSPECTION BEFORE USE:
Check that the glove does not present holes, cracks, tears, colour change etc.
If the product becomes damaged it will NOT provide the optimal protection and
must be disposed of. Never use a damaged product.
SHELF LIFE: The nature of the materials used in this product means that
the life of this product cannot be determined as it will be affected by many
factors, such as storage conditions, usage etc.
CARE AND MAINTENANCE
The user bares sole responsibility for submitting the product to mechanical
washing after use, as unknown substances can contaminate the product during
use and may affect the performance levels of the product. To care for your
product, we recommend that you rinse in cold water and line dry in room
temperature.
DISPOSAL: According to local environmental legislations.
EN ISO 21420: The glove contains natural rubber which may cause allergy.
ALLERGENS: This product may contain components that may be a potential
risk to allergic reactions. Do not use in case of hypersensitivity signs. For
more information contact Ejendals.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>