GLOBIZ 55069C Reversing Camera Built into the License Plate Frame 12V Instructions
- June 6, 2024
- GLOBIZ
Table of Contents
GLOBIZ 55069C Reversing Camera Built into the License Plate Frame 12V
Feature
Replace your conventional license plate holder with a version that includes a camera. You can easily insert the cables for the license plate light. The vertical tilt of the camera can be adjusted over a wide range.
- Easy to install
- Compatible with all cars
- Adjustable camera
- Wide-angle view
- Built-in 4pcs LED
- RCA signal cable connecting to the display (the display is not part of the set!)
- Power source: 12V
- Camera viewing angle: 170°
Resolution
- Set includes: 1 pc license plate frame 1 pc reversing camera 1 pc set of cables
- Size: 545 x 140 x 35 mm
- Signal cable length 6 m
- Color: Black
- Material: Plastic
- Protection: IP67
Warning
- The surface of the sensor must be kept clean!
- When reversing, always check the environment, look around and use the rear-view mirrors!
- Reverse at low speed to react to unexpected situations!
- Have the appliance installed by a specialist!
- Disconnect the cable from the battery (+) terminal before installation.
Wiring
- Connect the wires with the red connector to the reversing lamp connector and provide adequate insulation.
- Connect the black cable to a ground cable or a point on the car body.
- Use the yellow RCA cable to transmit the video signal to the display.
- You can mount the camera in place of a standard-sized license plate frame.
- After mounting, place the license plate in the frame by inserting the upper edge of the license plate from below under the camera bracket. (We recommend using double-sided adhesive on the back of the license plate if required)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>