FPC SECURITY FPC-5564 Electric Drop Bolt Exit Button and Receiver Installation Guide
- June 6, 2024
- FPC SECURITY
Table of Contents
FPC SECURITY FPC-5564 Electric Drop Bolt Exit Button and Receiver
This Diagram is for kits: FPC-5564
ATTENTION! QUICK TIPS, MUST READ BEFORE INSTALLING
- Make sure to cut off the connectors on both power supplies, then strip the wire leads before installing .
- In order to properly install this kit it is recommended that you use 18/2 or 20/2 gauge wire .
- Before installing this kit, check with your local fire Authority for the compliance of fire codes .
- In order to locate where you can Identify the+, – NC, NO or Open contacts on the receiver or exit button please refer to the manual of the exit button and receiver .
- We are not responsible for the improper Installation of this kit. This is an example of how it should be installed but all applications are different.
- If you are not handy with electrical components, please consult with a certified electrician or Locksmith .
- Make sure that when you are installing this kit, please have all components turned off. We are not Responsible for any type of short circuits.
Need assistance? Contact Us: 1-888-504-3318 | support@fpc- security.com | www.fpc- security.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>