Candy CDI1012 Dishwasher Instruction Manual
- June 6, 2024
- Candy
Table of Contents
Candy CDI1012 Dishwasher
Control Panel
- A “ON/OFF” button
- B Programme Description
- C “Programme” Buttons
- D “Half Load” option button
- E “Option Selection” light
- F “Programme Selection” lights
Programme settings
-
Open the door and place the dirty dishes inside the appliance.
-
Press the “ON/OFF’ button
-
After pressing the” ON/OFF” button, the indicator light which is factory set at “recommended”, or the indicator light for the “Auto’ Memory” programme will flash.
-
If you wish to select an option, press the option button (the corresponding indicator light will light up).
The option button can be selected or deselected WITHIN 2 minutes of the programme commencing. -
Choose a programme by pressing the corresponding button.
-
To start the programme, close the door.
Programme interruption
Opening the door when a programme is running is not recommended especially
during the main wash and final hot rinse phases. However, if the door is
opened while a programme is running (for example, to add dishes) the machine
stops automatically.
Close the door, without pressing any buttons. The cycle will start from where
it left off.
Changing a running programme
Proceed as follows to change or cancel a running program:
- Open the door.
- Hold down the current programme button (with the indicator light on) for at least 5 seconds. The programme indicator lights (except for the “RAPID” programme indicator light) will flash.
- The running programme will be cancelled and the indicator light for the “recommended” programme or the indicator light for the programme that was used at least 3 times consecutively will start to flash.
- At this point, a new programme can be set.
Programme end
At the end of the programme, the indicator light for the “recommended”
programme or the indicator light for the programme that was used at least 3
times consecutively will start to blink.
Dishes can now be removed and the dishwasher turned off by pressing the
“ON/OFF” button or dishes can be loaded for new cycle.
Option Button
“Half load” button
By using this option, it is possible to wash a smaller quantity of crockery:
you should load only the upper basket for dishes and place cutlery in the tray
in the bottom basket.
This reduces the water and energy consumption and requires a smaller quantity
of detergent.
Programme Guide
-
Universal (Recommended programme)
Once a day – for normally soiled pans and any other items that have been left all day for washing. -
Hygienic
Once a day – for heavily soiled pans and any other items that have been left all day for washing. -
Eco
Energy Saving Programme suitable for normally soiled items. Use detergents with enzymes. -
Rapid 32’
Quick wash for dishes that are to be washed immediately after the meal. Wash load of 4/6 persons. -
Cold rinse
Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>