EZVIZ WD8509 VGA WIFI Camera Instructions
- June 6, 2024
- ezviz
Table of Contents
EZVIZ WD8509 VGA WIFI Camera Instructions
Introduction
The Wi-Fi camera WD8509 is designed for the FPV hobbyist. This camera provides high-resolution video and images at VGA@20fps. The color and clarity of the image is superb, supporting MJPEG video compression technology, giving you the best picture possible and wireless FPV experience.
Main features
- WIFI streaming video
- Support Smart phone, Ipad devices
- support modes
- Main interface: GPIO、UART
- Working distance without obstacle and interference: 50m
Main application
- Monitoring
- RC tank, RC airplane etc
- Intelligent home
- Car Camera
Technical Index
| WIFI | 2.4G |
|---|---|
| Antenna type | Wire Antenna, 2dBi Gain |
| Image sensor pixel size | 640×480 pixels |
| Lens module | 1/4” M6 |
| Lens angel (deg.) | 65 degrees |
PCBA Board size
L(mm)xW(mm)xT(mm)
| ****
21.5 mm 17.6 mm 1.0 mm
Video Compression scheme
| ****
MJPEG
| HD resolution recording | 640×480 pixels 20fps |
|---|---|
| Video streaming (p) | 640×480 pixels 20fps |
| Protocol / Standard | IEEE 802.11b/n |
| Frequency Range | 2412MHz for 11b/n(HT20) |
| MODULATION TECHNOLOGY | DSSS，OFDM |
| MODULATION TYPE | CCK, DQPSK, DBPSK for DSSS |
64QAM,16QAM,QPSK,BPSK for OFDM
Transmission rate| 54/48/36/26/19.5/13/11/5.5 /1M
Transmit power| 11M| 13db
54M| 10db
Receiver sensitivity Working voltage/ current| 11M| -72dBm@10%PER
5.5M| -85dBm@8%PER
1M| -88dBm@10%PER
3.5-5.5V
220mA at 4.0v by idle mode, 200mA~400mA at 4.0v by real time video
streaming
| ****
-90dBm@8%PER
Wire connector| VCC (Red Wire)
GND (Black wire,close to red wire)
Working temperature| ****
0°C- 60°C
Working humidity| 10% -90% RH
Storage temperature| -40°C—70°C
Storage humidity| 5%—90% RH
|
Module Drawing
Operation introduction
Download the Free App that release by JHin Apple Store or Google Play. Turn on our WD8C25WiFi camera. The camera will take about 5 seconds to boot and power on. On your phone/tablet, turn on WiFi and search for the hotspotin the WLAN list. The WiFi camera has a built in WiFi hotspot so no other WiFi network is needed. NOTE: The camera will not link via Bluetooth – it is WiFi only. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure guidelines, place the product at least 20cm from nearby persons This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>