ROLLINGSQUARE 100513 Hyphen WaterProof Noise Isolating TWS Wireless Earbuds User Manual
- June 6, 2024
- ROLLINGSQUARE
Table of Contents
charging cable
Turn ON / OFF
Make sure to fully charge the charging case before the first use. Automatic:
take the earbuds out of the case to automatically turn them ON. Place the
earbuds into the case to automatically turn them OFF.
Manual: press the earbuds’ TCA area for 3s to turn them ON. Long-press
the earbuds’ TCA area for 5s to turn them OFF. The earbuds can’t be turned ON
in the charging case.
Pairing
- Take both earbuds out of the case.
- Earbuds’ LEDs breath not in sync while pairing to each other (this step is almost immediate).
- Select “HYPHEN L” or “HYPHEN R” on your device’s Bluetooth list to pair them both.
- To pair only one earbud, place the other in the charging case or turn it OFF manually.
Reset
- Make sure the charging case is not dead, turn OFF the Bluetooth on your device while both earbuds are in the case.
- Leave the earbuds in the case and long-press the two earbuds’ TCA simultaneously for 10 seconds until the earbuds’ LED turns ON red.
- Take out both earbuds from the case; they will pair to each other.
- Turn ON your device’s Bluetooth and select “HYPHEN L” or “HYPHEN R2
Charging the earbuds
Place the earbuds in the charging case to charge them; they will snap in magnetically. The earbuds’ LEDs will be ON while charging and OFF when the earbuds are fully charged.
Charging the Charging case
Via cable: plug the cable’s USB connector into a USB power source and the
cable USB-C connector into the charging case’s USB-C port.
Wireless charging: carefully lay the charging case on the wireless
charger’s surface.
Earbuds’ LED behavior
Status LED
| Charging | White |
|---|---|
| Battery 100%, earbuds in the charging case | OFF |
| Pairing to each other | Breathing not in sync |
| Pairing to phone | Breathing in sync |
| Paired to phone | 5 second white |
| During usage | OFF |
| Turn OFF | LED breathes red, then OFF |
Charging case’s LED behavior
Status while connected to a power source
| Battery between 0% and 20% | Breathing red |
|---|---|
| Battery between 20% and 60% | Breathing orange |
| Battery between 60% and 100% | Breathing white |
| Battery 100% | White |
To show the case’s battery level when not connected to the power source, double-tap the case’s side.
Advanced Touch Control
Choose your tips size Inside the packaging, you can find 3 different sizes of
tips. You can find the best fit for you by switching tips and trying all the
combinations.
The tips you’ll find on the earbuds are FHS M size.
FCC ID:2AS5Z-HYPHEN2
FHS ear tips configuration
The FHS ear tips have two different configurations, with or without the inner foam. As in the picture below, it is very simple to put it on or take it off by separating it from the external silicone. The two configurations provide different in-ear feelings and noise isolation.
Specifications
Bluetooth: 5.0
Weight: 58 g
Voltage input: DC 5 V Battery capacity:
– Earbuds: 3.7 V, 48 mAh – Charging case: 3.7 V, 500 mAh
Working time: Up to 540 min Charging time:
– Earbuds: 60 min
– Charging case: 60 min
Impedance: 16±15%
Supports: AAC, SBC, APTX, HFP 1.71, HSP 1.2, A2DP 1.31,| AVRCP 1.6, SPP 1.2,
PBAP 1.11, Device ID 1.3, AVCTP 1.4, AVDTP 1.3, MAP 11, GAVDP 1.3, RFCOMM 1.2,
TDS 1.0
Frequency response: 20 -20KHz
Distortion: THD+N:100/0 at 1KHz
Transmission distance: up to 30m / 100ft
Main material: ABS
Double channel support: YES
---|---
Safety information
– Listening at a high volume for long periods of time can cause hearing
damage.
– Do not insert the earbuds too deep into your ears, and never insert them
without ear tips.
– Keep the product, accessories, and packaging parts out of the reach of
children and pets to prevent accidents or choking hazards.
– Using these earbuds limits your ability to hear sounds around you,
regardless of the listening volume. Please be cautious when using this earbud.
– Do not use these earbuds when operating a motor vehicle, a bicycle, or
machinery, or when your inability to hear outside sounds may present a danger
to yourself or to others. – HYPHEN 2 is sweat and water-resistant. Sweat and
water resistance are not permanent conditions and resistance might decrease as
a result of normal wear. Do not attempt to charge wet HYPHEN 2. The charging
case is not sweated or water-resistant.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Preventing damages to the product and malfunctions
Always keep the product dry and do not expose it to extreme temperatures to
avoid corrosion or deformation. Clean the product only with a soft, dry cloth.
Intended use / Liability
These earbuds are designed for use with portable devices and hi-fi systems.
It is considered improper use when this product is used for many applications
not specified in the associated product guides.
The company does not accept liability for damage arising from the abuse or
misuse of this product.
Need help?
www.rollingsquare.support
Our Customer Support Team is always available for you.
Rolling Square® and HYPHEN®’ are owned and operated by Ferraris
Group Sagl, a company with its main offices in Corso San Gotta rdo 99, Chiasso
6830, Switzerland.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>