FENIX C6 V3.0 High Performance Rechargeable Work Flashlight Instruction Manual
- October 27, 2023
- FENIX
Table of Contents
LIGHTING FOR EXTREMES
C6 V3.0 High-Performance Rechargeable Work Flashlight
C6 V3.0
HIGH PERFORMANCE
RECHARGEABLE
WORK
FLASHLIGHT
| 1500 LUMENS MAXIMUM OUTPUT
---|---
| 300 METERS MAXIMUM BEAM DISTANCE
FENIX C6 V3.0 FLASHLIGHT
- 1500 lumens maximum output, 300 meters maximum beam distance.
- Uses a Luminus SST40 LED with a lifespan of 50,000 hours.
- Included a 2600mAh 18650 rechargeable Li-ion battery.
- Toughened ultra-clear glass lens with anti-reflective coating
- USB Type-C direct 2A charging; 2 hours for full charging.
- Digitally regulated circuit for maintaining a stable output.
- Magnetic base for hands-free use.
- Battery level indication and low-voltage warning.
- Made of durable A6061-T6 aluminum.
- Premium type HAIII hard-anodized anti-abrasive finish.
- Size: 5.24” x 1.26” x 0.91” / 133 x 32 x 23 mm.
- Weight: 3.63 oz / 103 g (excluding battery).
OPERATING INSTRUCTION
On/off
Press and hold the side switch for 0.5 seconds to turn the on/off the
flashlight.
Mode Switching
Press and hold the side switch for 1.2 seconds to switch between general mode
and flash mode.
Output Selection
In general mode, single click the side switch to cycle through Low →Med →High
→Turbo.
In flash mode, single-click the side switch to cycle through Strobe →SOS.
Strobe
With the light switched off, press and hold the side switch for 1.2 seconds to
enter strobe mode.
Intelligent Memory Circuit
The light memorizes the last selected output in general mode. When turned on
again the previously used output will be recalled. Each time the light will
enter the strobe when flash mode is selected.
Lock/Unlock
Lock: with the light switched off, double-click the switch within 0.5 seconds
to lock the light, the light will blink twice on Low to indicate locked
status.
Unlock: with the light locked, double-click the switch within 0.5 seconds, the
light will be unlocked and activated on Low.
*In locked status, clicking or pressing the switch will activate 2 one-second blinks on Low to indicate locked status.
TECHNICAL PARAMETERS
ANSI/PLATO FL1 | GENERAL MODE | FLASH MODE |
---|---|---|
Turbo | High | Med |
OUTPUT | 1500 lumens | 400 lumens |
lumens
RUNTIME| 1 hour*| 4 hours| | 17 hours| 54 hours| /| /
DISTANCE| 300 meters| 165 meters| | 85 meters| 45 meters| /| /
INTENSITY| 22500 candela| 6800 candela| | 1800
candela| 520 candela| /| /
IMPACT RESISTANCE| | 1 meter
SUBMERSIBLE| | IP68
Note: According to the ANSI/PLATO FL1 standard, the above specifications
are from the results produced by Fenix through its laboratory testing using
one Fenix ARB-L18-2600 Li-ion battery under the
Fenix laboratory environment. The true performance of this product may vary
according to different flashlights, working environments and the actual
battery used.
*The Turbo output is measured in a total runtime including output at reduced levels due to temperature or protection mechanism in the design under a good heat dissipation environment.
BATTERY SPECIFICATIONS
Type| Dimension| Nominal Voltage| Usability|
---|---|---|---|---
Fenix ARB-L18 Series| 18650| 3.6V/3.7V| Recommended| √√
Non-rechargeable Battery (Lithium)| CR123A| 3V| Usable (no charging)| √
Rechargeable Battery (LiFePO4)| 16340| 3.2V| Usable (no charging)| √
Rechargeable Battery (Li-ion)| 18650| 3.6V/3.7V| Caution *| !
Rechargeable Battery (Li-ion)| 16340| 3.6V/3.7V| Banned| X
Rechargeable Battery (LiFePO4)| 18650| 3.2V| Banned| X
- 18650 / 16340 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Only using quality batteries with circuit protection will reduce the potential for combustion or explosion, but cell damage or short-circuiting are potential risks the user assumes.
BATTERY REPLACEMENT
Unscrew the tail cap and insert the battery with the anode side (+) towards the light head, then screw the tail cap back on.
CHARGING
- Reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
- The indicator will display red while charging and will turn green when fully charged.
- Once charging is completed, be sure to tighten the light head to maintain the dustproof and waterproof ability.
Note:
- When charging, the flashlight can be normally used on Low mode, but charging time will be prolonged.
- Charge the light timely when the battery power gets too low to ensure the normal life of the battery.
- The normal charging time is approximately 2 hours from depletion to full charging.
- Recharge a stored light every four months to maintain the optimum performance of the battery.
BATTERY LEVEL INDICATION
With the light switched off, single click the switch to check the battery
status, the indicator will last for 3 seconds.
Green light on: saturated 100% – 85%
Green light flashes: sufficient 85% – 50%
Red light on poor 50% – 25%
Red light flashes: critical 25% – 0%
Note: This only works with Fenix ARB-L18 series 18650 battery.
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate a lot of heat when used at a relatively high mode for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user for reselection the mode.
INTELLIGENT PROTECTION
Intelligent Downshift
When the voltage level drops below the preset level, the flashlight is
programmed to downshift to a lower brightness level until Low mode is reached.
Low-voltage Warning
When the voltage remains low in Low mode, the light constantly blinks red to
remind you to timely recharge or replace the battery.
Note: This only works with Fenix ARB-L18 series 18650 battery.
- Disassembling the sealed head can cause damage to the light and will void the warranty.
- Fenix recommends using only a high-quality protected battery.
- If the light will not be used for an extended period, remove the battery for proper storage.
- Lock the light or remove the battery to prevent accidental activation during storage or transportation.
- Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
- Periodic cleaning of the battery contacts improves the light’s performance as dirty contacts may cause the light to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: Poor battery level.
Solution: Recharge the battery.
B: The contact or contact point of the battery or flashlight is dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing
alcohol.
If the above methods don’t work, please contact your authorized distributor.
INCLUDED
Fenix C6 V3.0 Flashlight, ARB-L18-2600 rechargeable Li-ion battery, USB Type-C charging cable, Lanyard, Spare O-ring, User manual, Warranty card
WARNING
-
The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the light directly into anyone’s eyes.
-
This flashlight will accumulate a lot of heat when used for extended periods, resulting in a high temperature of the flashlight shell. Pay attention to safe use to
avoid scalding. -
Do not shine an object at close range, to avoid burning the object or causing danger due to high temperature.
-
The LED of this flashlight is not designed to be replaceable; so the entire light should be replaced when the LED reaches the end of its life.
-
If any of the information provided in this manual is changed, the new version of the manual shall prevail; if your included user manual is an old one, it acquiesces that we won’t send a new manual.
LIGHTING FOR EXTREMES
|
---|---
https://www.facebook.com/fenixproducts/|
http://weixin.qq.com/r/83U_JiHEP3xArWVF9yDh
FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93 Fax: +86-755-29631181
E-mail: info@fenixlight.com Web:
www.fenixlight.com
Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku Road,
Fenghuanggang Community, Xixiang Street, Bao’an District, Shenzhen City,
Guangdong
Province, China
61.149.221.024-A1-20210506
Documents / Resources
|
FENIX C6 V3.0 High Performance Rechargeable Work
Flashlight
[pdf] Instruction Manual
C6 V3.0, High Performance Rechargeable Work Flashlight, C6 V3.0 High
Performance Rechargeable Work Flashlight, Performance Rechargeable Work
Flashlight, Rechargeable Work Flashlight, Work Flashlight, Flashlight
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>