ruwido 827A01 Remote Control User Guide
- June 6, 2024
- ruwido
Table of Contents
ruwido 827A01 Remote Control
user operating instructions
manual pairing
- power on STB
- press “play/pause” and “home” keys for 3 seconds to start pairing process (continuous red LED flashing) LED will stop flashing red if pairing was successful
- to delete pairing from remote control press “skip back” and “skip forward” keys for 3 seconds to delete pairing LED will flash 4 times red if pairing deletion was successful
LED behavior
- LED will flash red when the BLE command is transmitted
- LED will flash green when IR command is transmitted
factory reset
- to set remote control back to factory mode press and hold the “apps” + “left” key for a minimum of 3 seconds
- LED will flash 4 times red
declaration
User Information FCC 15.2:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Part 15 Statement. FCC 15.19/RSS Gen Issue 3 Sect. 7.1.3
This device complies with Part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Statement Class B Digital Device FCC 15.105:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>