Ruwido austria 850A BLE IR Remote Control User Guide
- June 5, 2024
- Ruwido austria
Table of Contents
2850-000 remote control user guide
Model 850A
Date: 2020-08-19
Version: 1
User operating instructions
1.1 manual pairing
– power on STB
– Press the play/pause and void buttons for 3 seconds to start the pairing
process (continuous orange LED flashing)
→ LED will stop flashing orange if pairing was successful
– to delete pairing from the remote control press 4 and 6 buttons for 3
seconds to delete the pairing
→ LED will flash 4 times red if pairing deletion was successful
1.2 LED behavior
top LED (STB)
– top LED will flash green when the STB BLE command is transmitted
– top LED will flash red when the STB IR command is transmitted
– top LED will flash orange during the BLE pairing process bottom LED (tv)
– will flash red when the TV / AMP IR command is transmitted
1.3 factory reset
– to set the remote control back to factory mode press and hold 7 + 9 buttons
for a minimum of 3 seconds
→ LED will flash 4 times red
Declaration
User Information FCC 15.2: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Part 15 Statement. FCC 15.19/RSS Gen Issue 3 Sect. 7.1.3
This device complies with Part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
copyright 2020 Ruwido Austria gmbh – this document is the intellectual
property of Ruwido Austria gmbh and contains information. reproduction,
modification, communication to third parties, and any other use is strictly
prohibited without prior written accordance with Ruwido.
ruwido_userguide_2850-000_model850A_2020-08-19.docx
Ruwido Austria gmbh
Koestendorfer Str. 8 . 5202 Neumarkt . Austria. t +43 6216 4571-0 .
office@ruwido.com.
www.ruwido.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>