hama 00201664 Slim5-HD 5000mAh Power Pack Instruction Manual

: June 6, 2024
: Hama

Table of Contents

hama 00201664 Slim5-HD 5000mAh Power Pack
Explanation of warning symbols and notes
Package contents
Safety instructions
Operation
- Charging the Power Pack
- Charging terminal devices
Care and Maintenance
Warranty Disclaimer
Technical Data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hama 00201664 Slim5-HD 5000mAh Power Pack

Thank you for choosing Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

High-density Li-polymer cells
This product contains high-density Li-polymer cells. High-density cells were developed primarily for smartphone production in order to accommodate the new very high demands in terms of capacity and performance with small space requirements. These new generations of Li-polymer cells allow a lightweight and compact design with comparatively high capacity.

Package contents

Power Pack “Slim 5-HD”
Micro-USB cable
These operating instructions

Safety instructions

Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
As with all electrical products, this device should be kept out of the reach of children.
Do not drop the product and do not expose it to any major shocks.
Do not operate the product outside the power limits specified in the technical data.
Do not open the device or continue to operate it if it becomes damaged.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
The battery is permanently installed and cannot be removed; dispose of the product as awhole in accordance with the statutory regulations.
Do not modify the product in any way. Doing so voids the warranty.
Donot use the product in areas in which electronic products are not permitted.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not incinerate the battery or the product.
Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.

Operation

Charging the Power Pack

Warning –Battery

Do not charge the power pack using your PC or the notebook. The charging currents can damage the USB port of the PC/notebook.
Only use suitable charging devices or USB connections for charging.
As a rule, do not charge devices or USB connections that are defective and do not try to repair them yourself.
Do not overcharge the product or allow the battery to completely discharge.
Avoid storing, charging or using the device in extreme temperatures and extremely low atmospheric pressure(for example, at high altitudes).
When stored over along period of time, batteries should be charged regularly (at least every three months).
Begin charging the power pack by connecting the included Micro-USB cable to the power pack’s port (IN 5V/1A)and to a suitable USB charger.Please refer to the operating instructions for the USB charger used.
Charging begins and ends automatically.
Charge the Power Pack fully beforeusing it for the first time.

Note –Capacity

The capacity is always shown when the Power Pack is charging.
Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated, this indicates that this capacity level has already been reached. The Power Pack is charged to at least 75% if three LEDs are illuminated, and the fourth is flashing.
If all four status LEDs light up, the full capacity is available.
Press the button of the Power Pack to switch it on and to check its current capacity.
To switch the power pack off, press and hold the button until the status LEDs go out.

Charging terminal devices

Warning –Connecting terminal devices

Before connecting a terminal device, check whether the power output of the charger can supply sufficient power for the device.
Ensure that the total power consumption of the connected terminal device does not exceed 1000 mA.
Please refer to the instructions in the operating manual of your terminal device.
It is essential that you observe these specifications and the safety instructions regarding the power supply of your devices.
The power pack must not be charged and discharged at the same time!

Warning

Never connect the charging cable of the PowerPack to both the input and the output of the Power Pack at the same time. This could damage the battery.
Don’t connect any terminal devices while the Power Pack is charging. This could damage the Power Pack and the connected device.
Connect the included Micro-USB cable to the USB port on the power pack (OUT 5V/1A)and to the Micro-USB port on your terminal device (mobile phone, smartphone, etc.).
The Micro-USB charging/connecting cable included may not be suitable for the USB connection on your terminal device. In this case, use the USB cable that was included with your terminal device.
Charging begins automatically. The status LEDs show the remaining capacity when the Power Pack is charging.
The current battery status of your terminal device will appear on this device.
Press and hold the button on the power pack to stop charging and to switch the power pack off. The status LEDs should switch off.
The PowerPack will automatically switch off if it is not connected to a terminal device.

Note –Optimised charging
Optimised charging means that the Power Pack recognizes the connected terminal device and supplies it with the optimal current to minimize charging time. Please note that the maximum power output of the power pack is 1000 mA.

Care and Maintenance

Only clean this product with aslightly damp, lint-free cloth and do not use aggressive cleaning agents.

Warranty Disclaimer

Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failuretoobserve the operating instructions and/or safety notes.