hama 00201661 LED10S 10000mAh Power Pack Instruction Manual

: June 6, 2024
: Hama

Table of Contents

Controls and displays
Explanation of warning symbols and notes
Package contents
Safety instructions
Operation
- Charging the power pack
- Charging devices
Care and maintenance
Warranty disclaimer
Technical data
Documents / Resources

hama 00201661 LED10S 10000mAh Power Pack Instruction Manual

Controls and displays

On/Off switch
2x USB-A connection
Micro-USB connection
LED capacity indicator
USB-C connection
Micro-USB charging cable

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package contents

Power pack with LED capacity indicator, 10000 mAh
Micro-USB charging cable
These operating instructions

Safety instructions

Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
As with all electrical products, this device should be kept out of the reach of children.
Do not drop the product and do not expose it to any major shocks.
Do not operate the product outside the power limits specified in the technical data.
Do not open the device or continue to operate it if it becomes damaged.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
The battery is permanently installed and cannot be removed; dispose of the product as a whole in accordance with the statutory regulations.
Do not modify the product in any way. Doing so voids the warranty.
Do not use the product in areas in which electronic products are not permitted.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not incinerate the battery or the product.
Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.

Operation

Charging the power pack

Start the power pack charging process by connecting the enclosed Micro-USB charging cable to the Micro-USB input on the power pack (IN 5V/2A) and to a suitable USB charger. Alternatively, you can also charge the power pack via the USB-C input (IN 5V/2A). To do this, consult the operating instructions for the USB charger you are using.
The charging process begins and ends automatically.
Fully charge the power pack once before using it for the first time

Note – capacity

During the power pack charging process, the capacity is displayed constantly.
The LED capacity indicator shows the current charge level in percent. The capacity indicator flashes during the charging process.
When the capacity indicator shows a constant 100%, the power pack is fully charged.
Press the button on the power pack to switch this on and to determine the power pack’s current capacity.
To switch the power pack off, press and hold the button until the LED indicator goes out.

Warning – rechargeable battery

Only use suitable charging devices or USB ports to charge the product.
Do not use defective chargers or USB ports and do not attempt to repair them.
Do not overcharge the product or allow the battery to completely discharge.
Do not store, charge or use the device in extreme temperatures.
Charge regularly (at least quarterly) during periods of prolonged storage.

Charging devices

Connect the enclosed Micro-USB charging cable to the USB port on the power pack (see 8. Technical Data) and to the Micro-USB port on your device (mobile phone, Smartphone, etc.).
In certain circumstances, the enclosed charging / connecting cable may not match the USB port on your device. In this case, use the USB cable that came with your device.
The charging process begins automatically. During the charging process, the LED capacity indicator indicates the power pack’s remaining available capacity.
The current battery charge status of your device is indicated on this.
Terminate the charging process and switch the power pack off by pressing the button on the power pack twice in quick succession. The LED indicator goes out.
In the event that no device is connected, the power pack switches itself off automatically

Warning – Connection of devices

Before connecting a device, check whether it can be adequately supplied with the power pack’s current delivery.
Ensure that the total current consumption of the connected device is not exceeded (see 8. Technical Data).
Note the instructions in your device’s operating manual.
You must obey the instructions and safety notes contained therein regarding the supply of power to your devices.
The power pack must not be charged and discharged at the same time!

Note – optimised charging

Optimised charging means that the power pack recognises the connected device, supplies it with the ideal current strength and therefore reduces the charging time to a minimum.

Warning

• Never connect the power pack’s charging cable to its input and output simultaneously. This can damage the battery.
• Do not connect any devices during the power pack charging process. Doing so can damage the power pack and connected devices.

Care and maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical data

Micro-USB input

|

5V 2A

---|---

USB-C input

|

5V 2A

USB-A output 1

|

5 V 2.1 A

USB-A output 2

|

5 V 2.1 A

Total output

|

2.1 A (max.)

Battery type

|

3.7 V/Li-Po

Min. capacity

|

10000 mAh / 37Wh

Typ. capacity

|

10250 mAh / 37.92 Wh

Usable capacity*

|

5900 mAh @5 V 2.1 A

The usable capacity is the capacity that can be drawn from the output sockets, measured at 5 V output voltage and a draw current of 2.1A.

Hama GmbH & Co KG
86652 Monheim/ Germany

Service & Support
www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.

****Raccolta Carta