hama 00201624 Charger Kit USB-C PD/QC 3.0 25W Instruction Manual
- June 6, 2024
- Hama
Table of Contents
Charger Kit, USB-C, PD/QC 3.0, 2.0, 25 W
00201623
00201624
Operating Instructions
Thank you for choosing this Hama product!
Take your time and read the following instructions and information completely.
Please keep these instructions in asafe place for future reference.
Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates arisk of electric shock from touching uninsulated
product parts that may carry hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
Package contents
- Charger
- Charging cables
- These operating instructions
Safety instructions
- Protect the product from dirt, moisture and overheating and use it in dry rooms only.
- Do not drop the product and do not expose it to any major shocks.
- Do not operate the product outside the power limits specified in the technical data.
- Do not modify the device in any way. Doing so voids the warranty.
- Do not continue to operate the product if it is visibly damaged.
- Use the product only for the intended purpose.
- As with all electrical products, this device should be kept out of the reach of children.
- Do not use the product in the immediate vicinity of heaters, other heat sources, or in direct sunlight.
- Route all cables so thereisnorisk of tripping.
- Do not bend or crush the cable.
- Always pull directly on the plug when disconnecting the cable, never on the cable itself.
- Dispose of packaging material immediately in accordance with the locally applicable regulations.
- The product is intended only for use inside buildings.
- Only use the article under moderate climatic conditions.
- Do not use the product in areas in which electronic products are not permitted.
- Do not use the product in adamp environment and avoid splashing water.
Risk of electric shock
- Do not open the device or continue to operate it if it becomes damaged.
- Do not use the product if the AC adapter, the adapter cable, or the mains cable are damaged.
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Operation
Note -mains voltage 100 -240 V
The charger is suitable for mains voltages of 100 -240 Vand therefore can be
used worldwide.
Please note that a country-specific adapter may be necessary.
Warning -connecting devices
- Before connecting device, check whether it can be adequately supplied with the charger’s current capacity.
- If ports USB-A1, A2, A3 are used simultaneously, the maximum output power (for technical reasons) is 15 W(5V /3A).
- Note the instructions in your device’s operating manual.
Note -Power Delivery /QC3.0, 2.0
- Plug &GO: no additional software required, simply plug in and start: Thanks to Power Delivery /QC3.0, 2.0, the voltage and power are adjusted automatically.
- Be aware that, for efficient and optimised charging, your terminal device must support the PD (Power Delivery)/QC 3.0, 2.0 function.
- If you have a large number of PD/QC-enabled devices with different firmware updates, it may be that the function is not fully supported.
Warning
- Only operate the product from asocket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
- Disconnect the product from the power supply using the On/Off switch –if this is not available, unplug the power cord from the socket.
- If using amulti-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
- If you will not be using the product for a prolonged period, disconnect it from mains power.
Unless different instructions have been expressly given in the operating instructions for the devices you are charging, proceed as follows:
- Connect your device to a USB charging socket using a suitable USB cable.
- Connect the charger to a properly installed and easily accessible mains socket.
- The charging process is displayed on your device.
- Disconnect the device from the charger if you wish to interrupt the charging process or when the device is fully charged.
- Then disconnect the charger from the line connection.
When charging the rechargeable batteries in the device, note the maximum charging times for the built-in batteries.
Care and maintenance
Only use soft, dry towels to clean the product.
Note
Disconnect the device from the mains before cleaning and during prolonged
periods of non-use.
Technical data
Specifications according to Regulation (EU) 2019/1782
Brand name, commercial register number, address| Hama, HRA12159, Dresdner Str.
9, 86653 Monheim,
Germany
---|---
Model identifier| 00201623, 00201624
Input voltage| 100 –240 V
Input AC frequency| 50 /60Hz
Output voltage / output current / output power total| 5.0 VDC/ 3.0 A/ 15.0 W
9.0 VDC/ 2.77 A/
25.0 W 3.3 -5.9 VDC/ 3.0 A/ 9.9 -17.7 W
3.3 -11.0 VDC/ 2.25 A/ 7.425 -24.75 W
Average efficiency during operation| 78.60%
Efficiency at low load (10%)| 80.00%
Power consumption at zeroload| 0.10 W
Warranty disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or from failure to observe the operating instructions and/or safety notes.
Hama GmbH &CoKG 86652 Monheim /Germany
Service &Support
www.hama.com
+49 9091 502-0
All listed brands are trademarks of the corresponding companies.
Errors and omissions excepted, and subject to technical changes.
Our general terms of delivery and payment are applied.
00201623_00201624/03.22
Documents / Resources
| hama
00201624 Charger Kit USB-C PD/QC 3.0
25W
[pdf] Instruction Manual
00201623, 00201624, Charger Kit USB-C PD QC 3.0 25W, 00201624 Charger Kit
USB-C PD QC 3.0 25W
---|---