hama 00201517 Magnet Vent Universal Smartphone Holder Instruction Manual
- June 6, 2024
- Hama
Table of Contents
00201517
Universal smartphone holder “Magnet”,Vent
Universal-Smartphone-Halter
Operating Instructions
Thank you for choosing aHama product.
Take your time and read the following instructions and information completely.
Please keep these instructions in a safe place for future reference. If you
sell the device, please pass these operating instructions on to the new owner.
Explanation of warning symbols and notes
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
Package contents
- 1x “Magnetic” Universal Smartphone Holder
- 2x metal plates (round, rectangular)
- these operating instructions
Safety instructions
- Use the product only for the intended purpose.
- Protect the product from dirt, moisture, and overheating and use it in dry environments only.
- When using this product, observe the applicable local traffic laws and regulations.
- Do not drop the product and do not expose it to any major shocks.
- Dispose of packaging material immediately in accordance with the locally applicable regulations.
- Do not modify the product in any way. Doing so voids the warranty.
Warning -magnets
- People with pacemakers should keep away from magnets. The magnets can negatively affect the function of the pacemaker.
- Do not place any bank or similar cards with magnetic strips or magnetically sensitive objects on the product. The data on the cards could be damaged or completely deleted.
Warning
- Take care that components such as airbags, safety areas, controls, instruments, etc., and visibility are not blocked or restricted.
- While driving a car or using sports equipment, do not allow yourself to be distracted by your product and keep an eye on the traffic situation and your surroundings.
Installation
Note
- Before installing the holder, check the installation options in your vehicle. If in doubt, check the vehicle’s instruction manual or contact the vehicle manufacturer.
- Check the load-bearing capacity of the slats before inserting a device into the holder. This installation version is only recommended for devices <300 g.
- Never apply force when using the product or during installation.
- Slide the grating clamp (A)carefully onto the open slats of the grating.
- To remove it, carefully pull the holder out of the grating.
- Remove the protective film (B)from the adhesive side of the metal plate (round or rectangular) and press it onto the desired adhesive surface (e.g. rear of a mobile phone) for a few seconds.
- The metal plate (C)can simply be inserted/stuck between the protective cover and the rear of the mobile phone.
Care and maintenance
Only clean this product using a lint-free, slightly damp cloth, and do not use any harsh cleaners.
Warranty disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, and improper use of the pro.
Hama GmbH &CoKG
86652 Monheim /Germany
Service &Support
www.hama.com
+49 9091 502-0
Alllistedbrandsare trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
00201517/03.22