EKEN Wireless Doorbell Camera 1080P with Chime User Guide
- June 6, 2024
- EKEN
Table of Contents
EKEN Wireless Doorbell Camera 1080P with Chime
The Basics
Getting started
Set up your chime with the video doorbell.
Step l
Before the setup process, be sure your video doorbell has connected to your
phone and plug in your chime.
Step2
Press the Connect Button.
Step 3
Press the Doorbell Button to pair your doorbell to the chime.
Step4
Press the Tune Button to cycle through 38 different tunes and select a tune.
Steps
Press the Doorbell Button again to make sure it’s the tune you selected.
Declaration of conformity
Herby.Building E, Urban Construction Industrial Zone, No.
1 Fenghuang Lingxia Road, Fuyong Street, Baoan District, Shenzhen,declares
that this Chime, Chime 2, Chime 3, Chime 4, Chime 5, Chime 6, Chime 7, Chime
8, Chime 9, Chime Pro, Chime Plus, Chime is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. In
accordance with Article 10(2) and Article 10(10), this product allowed to be
used in all EU member states.
Use the Chime in the environment with the temperature between -40 -C and 80 -C
Manufacturer: EKEN GROUP LIMITED
Address : Building E, Urban Construction Industrial Zone,
No. 1 Fenghuang Lingxia Road, Fuyong Street, Baoan
District, Shenzhen
Tel: 0755-23351483
Fax: 0755-23351483
E-mail: Amanda@eken.com
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>