MOZA NANO SE Selfie Stick Gimbal User Manual
- June 6, 2024
- Moza
Table of Contents
MOZA NANO SE Selfie Stick Gimbal User Manual
Instructions
While the gimbal is off, slide the mobile phone into the center of the phone holder according to the sticker and make sure the phone is well balanced.
Power Button
Long press for 3s: Power On/Off
Short press for 0.5s: Sleep Mode/Wake Up
Button (Top Button)
Click: Switch between horizontal and vertical shooting modes
Double click: Switch between Follow and Lock mode
Triple-click: Switch between front and rear camera
Button (Left Button)
Click: Switch shooting templates in Magic Video
Hold: Zoom out
Double click: Automatically zoom out
Button (Right Button)
Click: Switch shooting templates in Magic Video
Hold: Zoom in
Double click: Automatically zoom in
Record Button (Down Button)
Click: Shooting/Recording
Double click: Switch between Shooting and Recording
Mobile Phone Bluetooth Connection
Search for the device Hi-NanoSE-12BB4004XXXX on your mobile phone Bluetooth, click pairing, after the connection is completed, you can control your phone camera via the gimbal.
Technical Support: support@gudsen.com
Download the App
Please scan the QR code to download the MOZA Genie App prior using the MOZA NANO SE.
Protect The Environment
Paperless complete manual available online
To reduce the resources consumption and protect the environment, the completed user manual will not be provided on paper. You can download it from the official website or check it on the MOZA App.
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>