hama 00213011 Protective Glass for Apple iPhone 13 Mini Instruction Manual
- June 6, 2024
- Hama
Table of Contents
hama 00213011 Protective Glass for Apple iPhone 13 Mini
Operating Instructions
Thank you forchoosingaHamaproduct. Take your time and read the following
instructions and information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please pass these
operating instructions on to the new owner.
1. Explanation of Warning Symbols and notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
This symbol is used to indicate additional information or important notes.
Package Contents
- Protectiveglassfor display
- Microfibre cloth
- These installation instructions
The glass screen protector is shipped with a backing film or board. Only remove this protection when instructed to do so by these operating instructions.
Safety Notes
Small splinters of glass can lead to injuries if touched. Dispose of the product immediately if it is damaged or splintered during application or use. • Only touch the damaged or splintered product on undamaged areas and the edge. • Be very careful while doing so, thoroughly wash your hands afterward and avoid contact with your face and eyes.
Installation Requirements and Preparations
Select a room with as little dust as possible to perform the installation (for instance the bathroom).
- Use a clean, level, and flat surface with no cloth covering as a work surface.
- Check that the screen protector glass is positioned correctly. To check, place the protector glass on your screen and determine the correct direction for subsequent mounting. Openings for speakers, microphones, cameras, etc. must be kept free.
- Before attaching the protective glass, clean the screen as thoroughly as possible. Any contamination on the screen, for example, dust, fingerprints or lint will be visible after the protective glass is attached and may negatively affect the adhesion.
A microfibre cloth that has been lightly moistened with lukewarm water is sufficient for the cleaning.
Do not clean using paper towels, kitchen towels, or abrasive cleaning agents under any circumstances. This will scratch or damage the surface of the screen!
Attaching the Protector
Remove the backing film or board from the adhesive side (1) of the protective glass using the pull tabs indicated. • Pay attention not to bend the protective glass. • Do not touch any exposed areas on the adhesive side of the protective glass. • Place the protective glass adhesive side down onto the display. While doing so, make sure the protective glass is aligned with the outer edges of the display and that all the cutouts, such as the opening for the loudspeaker, match up. • If the protective glass is positioned incorrectly, you can pull it off and repeat the procedure. • Use a microfibre cloth to gently and uniformly smooth the protective glass on the display. • Smooth any remaining air bubbles from the middle outwards using a microfibre cloth.
Most air bubbles will disappear after a short while since the protector glass does not fully flatten out on the display until then. However, if these air bubbles are due to dust, repeat the mounting procedure after a thorough cleaning. Use strips of conventional clear cellophane tape to aid in application and removal without touching the adhesive side of the protector glass.
Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>